Question about 2005 Dodge Stratus
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The battery is accessible without removing the left front wheel and tire assembly..
Verify that the ignition switch and all accessories are OFF.
Turn the steering wheel to the full left position.
Disconnect and isolate the negative battery cable remote terminal from the remote battery post.
WARNING: NEVER GET UNDER A LIFTED VEHICLE IF NOT SUPPORTED PROPERLY ON SAFETY STANDS.
Remove battery splash shield. Refer to the Body section of the service manual for the procedure.
Disconnect the heater blanket cord, if equipped.
Remove the short bolt from the battery hold down and remove the hold down (Battery Location).
Disconnect the negative and positive battery cables from the battery.
Slide the battery toward rear of vehicle and lift out of the battery tray.
Remove battery from vehicle.
Posted on Oct 18, 2009
you will have to deal with the u code first. This is a communication problem between computers. My first guess is you have a bad computer or an open wire somewhere. Their is no way a backyard mechanic can do this without the proper tools to diagnose and with the knowledge to not cause further damage.
Posted on Nov 02, 2009
Multiple miss-fire and miss-fire on #5. I would first change the sparkplugs then replace the distributor cap and rotor. There is a good chance this will fix the problem, but no guarentees.
Posted on Nov 09, 2009
jack up the car take the wheels off the caliper which holds the pads need to come off usally 2 bolts if you are replacing the rotors you may have to hit them with a hammer to break the free if they have little clips on the rotors you can grabb the clips with pliers and take them off you do not need to replace them make sure you push the pistons on the calipers back in clean and lube the pins and the any where the rest on the knuckle do get lube on the rotors put it all back together do the same on the otherside before you start the car pump the brakes until a good pedal then you are good to go i hope this helps you
Posted on Apr 13, 2010
Tips for a great answer:
Dec 12, 2013 | Cars & Trucks
Feb 21, 2018 | 2005 Dodge Stratus Sedan
Feb 01, 2013 | 2005 Dodge Stratus Coupe
Aug 16, 2012 | 2005 Dodge Stratus Sedan
Jan 19, 2018 | 2002 Dodge Stratus
Nov 09, 2009 | 2005 Dodge Stratus
Nov 02, 2009 | 2005 Dodge Neon
111 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: