Question about Dodge Cars & Trucks

Open Question

Tail light wiring diagram dodge nitro - Dodge Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 2007 Dodge Nitro Tail Light Replacement

look at the car manual under maintenance and then rear light bulb replacement. First take out the two hole covers using a flat head to loosen then wiggle and turn by hand to get out. Pull the light unit straight back, and unplug the electrical. Don't break anything.
Then use a star driver (check your misc socket set drivers for the right size). Unscrew the two star head screws and pull this bulb holder straight off the tail light (same direction as screws). Replace the bulb and put back together in reverse.

Posted on Apr 17, 2009

Ad
  • 1 Answer

SOURCE: schematic diagram of 2005 dodge caravan tail

Bought a circuit tester used it to determine what each wire went to.

Posted on Jan 07, 2010

ftw1952
  • 10319 Answers

SOURCE: tail light wiring connectors and wiring diagram

A test light checking each connector would be faster and easier to do. Maybe somebody may have a illustration for you but by far a simple test light is all you need with a helper turning on the different lights as you check them out and writing all your findings down

Posted on Jan 22, 2010

  • 1 Answer

SOURCE: 2004 tail light wire diagram/colors, need both bra...

I can't get my brake lights to work. the rear one in the window works but the tail ones won't work.do you have any ideas as of what to try to fix this problem. Thanks!
JO

Posted on Jul 03, 2010

  • 1 Answer

SOURCE: 2008 dodge nitro change oil light how to turn off ...

Directions are in the book, but you would put the key in and turn it all the way, just don't start engine. Pump gas pedal all the way to the floor 3 times slowly, but it has to be with 10 seconds. Turn key off and when you start again, oil changed chime and warning should not be on. If it is, try again.

Posted on Jul 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can I get a wiring diagram for a 1997 Dodge RAM 3500 diesel pickup?


1997 3500 Wiring Diagram - Dodge Diesel - Diesel Truck Resource Forums

www.dieseltruckresource.com/...dodge-ram.../1997-3500-wiring-diagra...
Jan 24, 2011 - Hey guys, I'm working on a 97 3500 that's had the bed removed and replaced with a flatbed. There is the biggest mess under that truck wiring wise and. ... 2007 Ram 3500 A/C compressor wont engage, need wiring diagram ...

Dodge Wiring Diagrams / Schematics - YouTube

? 1:13
https://www.youtube.com/watch?v=UI6_vhCHFYU
Nov 19, 2013 - Uploaded by Robert Nauert
Dodge Wiring Diagrams / Schematics ... Nitro, Power Wagon, Ram 1500, Ram 2500, Ram 3500, Ram 4500 ...

1997 Dodge Cummins - Full color wiring diagrams - 12 Valve ...

forum.mopar1973man.com/.../1638-1997-dodge-cummins-full-color-wi...

Jan 01, 2016 | Dodge Cars & Trucks

1 Answer

Wiring diagram running light, need wiring diagram for 2006 dodge dakota ,right tail light is out but brakeand turn signal works


With a test light check if you have power there with lights on and with lights off, compare left side with right side as far as location in the tail lamp plug for the tail lamp park lights.Trace the harness back to the left side underneath usual corrosion in this area.

Aug 30, 2014 | 2006 Dodge Dakota

1 Answer

What is the color code for 2007 dodge nitro tail lite wire harness ?


I have a 2010 Jeep which is a Dodge product that I went to install
Led lights in and put load resistors in and all that happened is the
blinkers flashed faster then they should. don't bother its a waste of time & energy the Factory lights are just as bright and bulbs are less expensive & easier to replace.

Aug 27, 2014 | 2007 Dodge Nitro SXT

1 Answer

Wiring diagram for dodge caravan 1998 tail ligth, back light, ect.


Wiring diagrams are copyrighted material and cannot be posted here. However, you can get full access to all of the service information for your vehicle (including wiring diagrams) for a small annual fee at alldatadiy.com

May 19, 2012 | Dodge Caravan Cars & Trucks

1 Answer

I need a diagram for a serpentine belt for a 2007 Dodge Nitro


The diagram you requested appears below:

2007 Dodge Nitro 4.0L V6 Serpentine Routing

greg_margo_30.jpg

Oct 08, 2011 | 2007 Dodge Nitro R/T New Cars

1 Answer

When I press the brake pedal only the left brake light comes on. The bulbs are good and the fuses are all good. Replace the right light modual but still no help. this is on a 2008 Dodge Nitro


How do you know the bulb is good? Even if it uses the same bulb as the tail light it is always a different filiment. But if you tried replacing the bulb and the fuse than it has to be the wiring. If it's a 2008 it should be covered by the warranty, I would bring it into the dealer.

Aug 17, 2011 | 2008 Dodge Nitro

1 Answer

I need a spark plug wire diagram for a 2007 dodge nitro i think that i may have them crossed if someone could help me out it would be appreciated


you shouldnt need a diagram there should be numbers on the tension leads coming from the distibutor and numbers on the engine block near the spark plugs just match the numbers and the leads are usually different lengths, also the distibutor cap has to be in the correct position if not it is basically the same as crossing the wires and putting them in the wrong spot which will stuff up the firing order

Jun 12, 2009 | 2007 Dodge Nitro R/T New Cars

2 Answers

2007 replacement light bulbs


If none of local autoparts stock them, you'll have to go to dealer.

Mar 07, 2009 | 2008 Dodge Nitro

2 Answers

2007 Dodge Nitro Tail Light Replacement


look at the car manual under maintenance and then rear light bulb replacement. First take out the two hole covers using a flat head to loosen then wiggle and turn by hand to get out. Pull the light unit straight back, and unplug the electrical. Don't break anything.
Then use a star driver (check your misc socket set drivers for the right size). Unscrew the two star head screws and pull this bulb holder straight off the tail light (same direction as screws). Replace the bulb and put back together in reverse.

Nov 04, 2008 | 2007 Dodge Nitro R/T New Cars

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...