Question about Seat Arosa

Open Question

Change seat arosa side light

The bulb spin do i need special tool to remove it

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: cannot remove tail light assembly

I had the HARDEST time with the lights...I never realized changing a bulb would be so difficult. Once you unscrew what you need to, go into the trunk and pull the lining away from the back part of the light. There are the white prongs that you will need to tap with a hammer until they pop out and then the light assembly will come out. Be careful though, I got a little too impatient and broke mine. I used a binding agent to hold it back in place though...GOOD LUCK!

Posted on Nov 29, 2008

Ad
  • 396 Answers

SOURCE: how to replace brake light in rear window

The housing should jump pop up using a screw driver. Push the bulb down and twist out.

Posted on Jun 27, 2009

  • 13 Answers

SOURCE: Changing parking light bulb in front

Fisrt of all remove the Plastic fixings from the top of grill then carefully place your hands in the bottom grill slots and give a sharp pull,this should release the inner push type fixings (4 in all, one on either side of the headlamp towards middle of car and one either side at the wing)(very tight fit) the to release the outer edge ones carefully run your hand along the bottom of the headlamp and behind the plastic bottom edge of the grill the till you get as close to the wing as possible,then another sharp pull.Do this again for the other side and you good to go.On refiting make sure the two wing end pins are placed in first as these can be a pain if not inserted properly.. Hope this helps

Posted on Aug 13, 2009

  • 52 Answers

SOURCE: Need to change right side indicator bulb

open bonnet and in front panel is plastic flap which needs to be removed, then inside using a 5mm 1/4 drive socket and extension turn screw to release headlamp, it will click to release then foce the lamp out of appature. refitting is the reverse

Posted on Sep 06, 2009

SamThePirate
  • 77 Answers

SOURCE: Can I replace my seat belt myself or do I need a professional?

You might be ablr to find a relplacement part but if you go to the dealer for it I doubt they will sell it to you. And yes, special tools are required!

Posted on Jan 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the cupholder on a seat arosa


I believe there are 2 torex T20 screws on each side. Same as VW Lupo and Skoda.

Oct 30, 2012 | Cars & Trucks

2 Answers

How to fit a seat arosa automatic inhibitor????


Yes i have worked on these cars but never seen a auto version as yet ?if you get a new one then you will see where it has to fit as some are inside the gearbox and some on the linkage but wherever it is it will be the same as a VW polo and one i done on a old golf was under the mechanism in the cab for the gearchange and wasnt too difficult to change

Mar 03, 2012 | Seat Arosa Cars & Trucks

1 Answer

Sear arose side light


what do you need to know ???

Feb 11, 2012 | 2003 Seat Arosa

1 Answer

How to replace headlight bulb on passenger side


On your 4x4 need to remove head lamp assembly to change the burnt bulb.There is no need of special tools but I recommend the job to be done by VW electrician.

Jun 28, 2011 | 2004 Volkswagen Touareg

2 Answers

How do you take the plastic cover off the driver side read light as the bulb need replacement and what is the bulb replacement number to purchase


To change the bulb. Using the trim tool or a very small screwdriver. Start on the windshield side. Slowly pry the cover tabs out. Do not do this on the side towards the seats it will break off the tab that turns the light on & off. WINDSHIELD SIDE ONLY!!!!!!!!!!

Jan 07, 2010 | 2007 Dodge Caravan SXT Minivan New Cars

1 Answer

How to change side marker bulb in 1997 altima


a53bade.gif

The marker lights are removed by depressing the tab (arrow) with a thin bladed tool. Take care not to scratch the paint

  1. Disengage the bulb and socket assembly from the lens housing.
  2. Gently grasp the light bulb and pull it straight out of the socket.
To install:
  1. Before installing the light bulb into the socket, ensure that all electrical contact surfaces are free of corrosion or dirt.
  2. Line up the base of the light bulb with the socket, then insert the light bulb into the socket until it is fully seated.
  3. To ensure that the replacement bulb functions properly, activate the applicable switch to illuminate the bulb which was just replaced. If the replacement light bulb does not illuminate, either it too is faulty or there is a problem in the bulb circuit or switch. Correct as necessary.
  4. Install the socket and bulb assembly into the lens housing.

Dec 07, 2009 | 1997 Nissan.5 Altima

1 Answer

Driver light out how to replace bulb need special tools?


Headlight Bulb Removal & Installation To Remove:
  1. Disconnect and isolate the negative battery cable.
  2. Remove the headlight assembly mounting screws.
  3. Pull the assembly forward and disconnect the bulb connector.
  4. Turn the bulb retainer ring counterclockwise and remove the bulb from the headlight assembly.
To Install:
NOTE: Do not handle the glass portion of the bulb with your bare fingers.
  1. Install the bulb in the headlight assembly.
  2. Install the retainer ring.
  3. Connect the connector to the bulb.
  4. Install the headlight assembly in the vehicle.
  5. Connect the negative battery cable.
No special tools required.

Jun 24, 2009 | 2004 Dodge Caravan

1 Answer

I need to change the bulb in the analog clock in my 1999 Lincoln Towncar. How do I go about getting to it without tearing apart the dashboard?


you need a special tool to get the radio out. It has pins that spread out spring clips so the radio can pull out.

please rate as solved if this helps.

SECTION 413-00: Instrument Cluster and Panel Lighting — General Information 1999 Town Car Workshop Manual
REMOVAL AND INSTALLATION Bulb —Electric Clock
Special Tool(s) Radio Removing Tool
T87P-19061-A

2242b54.gif
Removal
  1. Disconnect the battery ground cable.
  1. Pull out the radio using Radio Removing Tool.
1475891.gif
  1. Remove the radio.
    1. Disconnect the electrical connectors.
    1. Disconnect the antenna cable.
    1. Remove the radio.
  1. Remove the instrument cluster finish panel bolts.
c7eab47.gif
  1. Remove the instrument cluster finish panel bolts.
054ed10.gif
  1. Pull out and position aside the instrument cluster finish panel.
cc71028.gif
  1. Disconnect the electric clock electrical connector.
  1. Remove the instrument cluster finish panel.
    1. Disconnect the headlight switch electrical connector.
    1. Disconnect the dimmer switch electrical connector.
    1. Remove the instrument cluster finish panel.
  1. Remove the electric clock illumination bulb.

Apr 23, 2009 | 1999 Lincoln Town Car

1 Answer

How to Change the headlight bulbs for my 1992 Buick Regal


A torque bit screw driver are a philips screw driver should be all you need. JUST MAKE SURE NOT THE TOUCH THE BULB (new bulb) WITH YOUR FINGERS. Your body oil will make the bulb burn out quick!!!! Wear rubber gloves when installing the new bulb. f one is dim, you better change both sides. are the other side will also be dim.

Feb 06, 2009 | 1992 Buick Regal

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

217 people viewed this question

Ask a Question

Usually answered in minutes!

Top Seat Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

yadayada
yadayada

Level 3 Expert

77169 Answers

Adam Truesdale

Level 2 Expert

344 Answers

Are you a Seat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...