Question about Cars & Trucks

Open Question

Fuse keeps blowing for my brake lights and dash board on fiesta mk4

My 15amp fuse that runs my dash board and brake lights started to pop so kept getting new ones and it kept popping them sometimes after one day, but sometimes after 5 or 6. Now I'm on my 19th in 3 weeks and now as soon as I put a new one in and turn my car over it just pops straight away. Cant afford for a mechanic to look at it as been told if its to do with the wires its a costly job and my car is not worth enough to pay out and fix it. So any solutions ?

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

'99 Ford Crown Vic LX: #12 30A Maxi fuse blows seconds after starting or ignition turned on.


i had this problem with my 1999 jeep grand cherokee laredo with the brake lights it kept popping fuses right after the ignition was turned on try putting a higher amp fuse in place of the old one that keeps blowing then check for shorts to the starter and check grounds and wires and also the transmission issue check the fluid and then if the fluid is fine change the transmission filter the filter may have not gotten replaced when the transmission was rebuilt and may be clogged or dirty

Oct 04, 2012 | 2002 Ford Crown Victoria

2 Answers

Hi can i bypass my ABS on my Fiesta 2009. My brakes only works rite when the ABS lights up on the dash....Before it lights up the brake are hard then you have to pump it a little the brake was bleeded


Lots of ways,,
Just pull the fuse ,unhook a wheel sensor,unplug the control box,
Anything to cause a fault,
As long as the ABS light is on you will have normal base brakes.
(I prefer mine like that)
Be sure the RED brake is not on however.
Hope this helps.

Jul 01, 2012 | Cars & Trucks

2 Answers

My tail lights wont turn on when I turn on front lights


its your running light fuse under driver dash board or on side of it

Dec 29, 2011 | 1994 Honda Accord

1 Answer

I have a 2002 XL7 and the fuse for the dash lights and tail lights keeps blowing. I've changed it three times now - the lights will work for a few days and then the fuse will blow again.


something is shorting to ground...look for any bare wiring...i had one time ..a brake light fuse kept blowing...after about 2 days found out it was the bulb it self (it was working too)...strange ???

Jun 07, 2011 | 2002 Suzuki XL-7

1 Answer

My brake light and interior dash lights keep blowing the fuse, every time we change it and restart the car the fuse blows again, and the engine runs great, and some times when it is ran for a while you cut...


mcdevito75 here, I would try to isolate the problem with the fuse blowing, ---- sit in the car and step on the brake, without the car running see if the fuse blows, the just put the key to on not strat just on see if the fuse is blow, if it is you may have a problem under the dash, if not, now with the key just on no start, step on the brake see if that fuse is blow, if so you may have a problem at the brake light switch under the dash or at the brake lights themselves at the back of your car, a bad ground, loose or broken wire, inspect if you can. The hard or no starting after you drive for a while could be related or a problem with the ignition coils or ignition module. In any event have your local auto re[pair shop check these items out for you, a short could cause real problems in your car.

Jun 02, 2010 | 1997 Pontiac Grand Prix

3 Answers

My daughters 1998 honda accord ex keeps blowing fuses she is having to replace the brake light fuse after we replaced the brake light switch when she changed the fuse last the horn blew and she was shocked...


The horn and rear brake lights are on the same fuse. Eventually the horns rust out like on my 1998 CRV. Once I replaced the horns, I could put in a new fuse without it blowing every time I sounded the horn. Problems still remain, namely: the cruise control does not engage and the remote start only starts the engine that runs for two seconds then dies. Still looking for an answer. It's a "Code Alarm" with Codestart dated 11/24/99.

Jan 05, 2010 | 1998 Honda Accord

1 Answer

Keep blowing fuse for rear taillights and dashboard lights


Sounds like loose wires. Had a similar problem with my 03 Durango. Kept blowing fuses when I put them in. Came to find out my trailer wiring harness had fried and was shorting out.

Apr 07, 2009 | 2001 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...