Question about 2002 Jeep Grand Cherokee

Open Question

Location of cooling fan sensor jeep liberty 2003

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Mikey108
  • 475 Answers

SOURCE: 2003 jeep liberty air bag light on is it easy to fix

The system needs to be checked for cades. Airbag codes are pulled out of the ECU with the use of a scanner tool. A good auto mechanic shop will have this or you can go to the dealer. YOU SHOULD NOT TRY TO REPAIR THIS YOURSELF,YOU COULD ACTIVATE THE AIRBAG!!!!!

Posted on Nov 11, 2008

Ad
jmeyer847
  • 185 Answers

SOURCE: P0340 code in my Jeep Liberty 2002

Since a P0340 Could be either the Cam Position Sensor or The Crank Position Sensor they are obviously in 2 different spots, however they both either sit on the back of the engine or on the transmission bellhousing. Your Cam Sensor is at the top and your Crank Sensor is near the bottom.

Hope this gives you some direction. Thanks for using FixYa!

Sincerely,

JC

Posted on Nov 21, 2008

Brian032472
  • 150 Answers

SOURCE: 2003 Jeep Liberty heater fan problem

It is the blower motor resistor. Look under the passanger side dash and locate the fan housing (looks round and black in color. Then locate the resistor it will be in that housing usually withtwo ten millimeter nuts or two simple screws holding it in. unplug the harness to the resistor and remove the resistor. Part store price is approx. 50.00. Note: on aftermarket (not Jeep) resistor sometimes you have to modify the housing a little to get it in. Hope this helps.

Posted on Feb 01, 2009

c17hydro
  • 2984 Answers

SOURCE: Identifying 2003 Jeep Liberty Automatic Transmission

What is your VIN number?

Posted on Mar 31, 2009

  • 153 Answers

SOURCE: How to change spark plugs on a 2003 jeep liberty?

The plugs are probably under the coil packs, You will see a series of wiring harnesses with 3 or 4 wires in each connector that plug into a square or rectangular piece that is usually bolted down to the center of the valve cover(s). You have to remove these and the plugs are under them. Be gentle with the harness conectors and take your time as the underhood temps tend to make them brittle

Posted on Sep 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the position of radiator fan relay on jeep liberty 2006


no idea to be honest earlier jeeps had then at the front of the wing down below as i remember ?? newer one would i imagine be in the electrical box under the bonnet near the battery

Dec 02, 2016 | Jeep Cars & Trucks

1 Answer

Will a leak cause the radiator fan relay curcuit to malfunction on a 2003 jeep liberty 3.7


a leak in coolant system will cause air pocket in the coolant system around the engine coolant temperature sensor.coolant sensor is a thermistor in which when hot cool cause it resistance decrease which affect the voltage from sensor to pcm which will cause engine coolant to turn on.if coolant level okay,check coolant fan fuse and relay, if all is good,engine coolant temperature sensor could be bad or have vechicle code scan for pcm problems it control the coolant fan.fill coolant system to correct level make sure engine coolat reservoir is at full cold mark and not empty.fill coolant system check for leaks,refill coolant overflow jug back to full cold mark dont over fill, if coolant overflow stay empty you have leak either its leaking or you have radiator hoses or radiator leaking coolant.when coolant overflow jug run dry it cause air get in coolant system causing overheating problems.

Jul 25, 2012 | 2003 Jeep Liberty

1 Answer

2003 jeep liberty suddenly got hot and antifreeze was every where what is wrong?


It overheated.
You'll need to figure out if it is a faulty thermostat, water pump, cooling fan, or other causes.

Jul 08, 2012 | 2003 Jeep Liberty

1 Answer

Mi jeep liberty 2002 fan doesn't turn on although i disconnect the temperature sensor, i have understood that if i disconnect it, the fan should turn on all time but it doesnt, i dont know what happens...


Having similar problem with an 03 Liberty. Replaced Radiator Cooling Fan Relay $82 and drill new mounting hole. Fan will not run after shutting off engine, so I'm thinking I have a bad thermostat or a bad cooling temperature sensor. Heading to the parts store now.

Apr 16, 2011 | 2003 Jeep Liberty

2 Answers

2003 Jeep Liberty. Starts out blowing cold air


it could be many things, maybe compressor heats up and shuts down, or cooling fans are cooling condensor or expansion valve is bad, a good tech will be able to diagnose this,

Mar 24, 2010 | 2003 Jeep Liberty

1 Answer

Have codes 0122,0123,1299,6500,6700,8307 for my 2003 jeep liberty


this could happen sometimes when a sensor is bad start by replacing the crank sensor that's located by your no. 1 piston it costs about 30.00 dollars and it's easy to replace it only has one two bolts good luck.

Sep 11, 2009 | 2003 Jeep Liberty

1 Answer

I have a 2003 Jeep Liberty. The radiator cooling fan stopped working and the car almost overheated. I replaced the relay with the new style with the cooling pins and the fan now comes on, though...


no but there are a couple of cooling fan switches that could be causing your problem both are mounted on the motor one near the thermostat housing the other will be in the block one near the thermostat usually controls the fans.

Aug 28, 2009 | 2003 Jeep Liberty

2 Answers

2003 3.7 Liberty check engine light for crank sensor


2003 3.7 Liberty check engine light for crank....what? sensor? You have scanned it?

Mar 06, 2009 | 2005 Jeep Liberty

2 Answers

2003 Jeep Liberty heater fan problem


It is the blower motor resistor. Look under the passanger side dash and locate the fan housing (looks round and black in color. Then locate the resistor it will be in that housing usually withtwo ten millimeter nuts or two simple screws holding it in. unplug the harness to the resistor and remove the resistor. Part store price is approx. 50.00. Note: on aftermarket (not Jeep) resistor sometimes you have to modify the housing a little to get it in. Hope this helps.

Feb 01, 2009 | 2003 Jeep Liberty

Not finding what you are looking for?
2002 Jeep Grand Cherokee Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...