Question about Cars & Trucks

1 Answer

Engine light stays on

When i turn the ignition half way round, the EPC & Engine lights stay on when the car starts the EPC goes out but Engine light stays on ??

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Scan for codes.

Posted on Apr 18, 2013


6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

honeymokey
  • 3113 Answers

SOURCE: BRAKE LIGHTS STAY ON, EPC LIGHT ON

Call dealerto replace brake light switch, some of them were covered under warranty. They were **** and they replaced all of them.

Posted on Apr 30, 2009

  • 1 Answer

SOURCE: audi tt 180 quattro car wont start. EPC and E-M system lights on

I would suggest you check oil levels etc. Generally these cars suffer from the air mass meter / air sensor problems aswell as coil problems too. Did you ever get a solution to the problem?

Posted on May 01, 2009

  • 36 Answers

SOURCE: 2003 AUDI Quattro 3.0 check engine light(MIL) stays on

Before you do anything else you are just going to have to read the codes. So buy the maintance book at autozone,locate the little juction box on the fire wall and jump the terminals with a little wire. Then of course sit in the drivers seat turn on the key(do not start) and read the blinks. Then you will know what the problem is.

Posted on May 06, 2009

freelander72
  • 124 Answers

SOURCE: Tail Lights & Brake Lights stay on even when car is turn off

the plastic round stopper most probably broke that is were the stoplight switch sits when not depressed easy fix find a washer small enough to block the hole were the original plastic stopper was making sure the washer aligns to the brake light switch and secure washer w/ zipties hope this helps.

Posted on Aug 13, 2009

FixinFax
  • 3085 Answers

SOURCE: 2003 Jetta 2.0 L Engine, MIL and EPC Lights ON

Probably a bad COIL-PACK

Posted on Sep 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Seat leon engine


disconnect negative battery cable for about 15 min & reconnect

Apr 21, 2014 | 2000 Seat Leon

1 Answer

Just replaced the ignition in 2005 impala how go I recode it to start the car


Takes about half an hour,be sure battery is charged,crank engine and leave key on(like you would if it started) security light should blink or stay on for about 10 minutes,when it goes out ,turn key off,crank engine again and leave key on,same thing for about 10 min, have to do this 3 times,3rd time engine should start and you're done.

Dec 14, 2013 | Cars & Trucks

1 Answer

2004 olds alero 3400 eng.turn on key and all warning lights and gauges come up,then all goes off after 3 seconds,starter will not work,can start by jumping across starter and runs fine and shifts fine


Check for power at the switch wire when someone turns the key to start. I would say there is a break in the circuit of the thin wire between the starter & the ignition switch

Oct 03, 2012 | 2004 Oldsmobile Alero

1 Answer

Engine emissions warning comes on with audio sound when initially starting (or switching the ignition on).Goes out after 5/6 seconds The emissions are fine Tried new air mass meter and new glowplugs.


First of all you need to access the Engine Control Module (ECM) using suitable diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC's memored. DTC = Diagnostic Trouble Code. Then you will bu full informed about the root cause of the problem, and you will be able to repair & replace bad pieces and reset the ECM. Then the EPC (Electronic Pedal Control) yellow light will turn OFF.

The check engine light:

tdisline_743.jpg


The check engine light & EPC light:

tdisline_744.jpg




Oct 21, 2011 | 2006 Volkswagen Golf

1 Answer

09 passat fsi epc light on engine starts wont rev also wen ignition turns on a clicking is heard[thats new] engine warning light came on after


First of all you need to access the Engine Control Module (ECM) using suitable diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC's memored. DTC = Diagnostic Trouble Code. Then you will bu full informed about the root cause of the problem, and you will be able to repair & replace bad pieces and reset the ECM. Then both EPC (Electronic Pedal Control) & engine warning yellow light will turn OFF.

Aug 01, 2011 | 2000 Volkswagen Passat 4Motion

1 Answer

Hi,My epc light goes on, stays on for at most a day and then dissapear again. This problem repeats itself often.


First of all you need to access the Engine Control Module (ECM) using suitable diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC's memored. DTC = Diagnostic Trouble Code. Then you will bu full informed about the root cause of the problem, and you will be able to repair & replace bad pieces and reset the ECM. Then the EPC (Electronic Pedal Control) yellow light will turn OFF.

Jul 11, 2011 | 2005 Audi A3

1 Answer

Epc light on


make sure the gas cap is tight. it may take driving for a week for the light to go out.

Jul 08, 2009 | 2003 Volkswagen Golf

1 Answer

2003 Prius sometimes will not start, engine light comes on. Removing key from ignition, reinserting key, & turning wheel till it locks will then allow the car to start. Engine light stays on for a


I had a wire connector on the front of the engine that had so much tension, the wires broke. I didn't notice until a wet day when the car wouldn't start (and the Check Engine light was on). (The error code was related to an Emissions error.) The connector is located on the engine, front, just left of center. Hope this helps!

May 25, 2009 | 2002 Toyota Prius

1 Answer

Engine emission sensor light


need to change your o2 sensor

Jul 14, 2008 | 1993 Honda Civic 4 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

215 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...