Question about 1997 Mitsubishi Mirage

Open Question

LOCATION 1997 MITSUBISHI MIRAGE MANIFOLD DIFFERINTAL SENSOR

WHERE IS THE MANIFOLD DIFFERENTIAL SENSOR CIRCUT LOCATED

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

dustyboner
  • 331 Answers

SOURCE: 2001 Mitsubishi eclipse failed smog

2.4L
7ee7958.jpg

----------------------------------------------------------------------------------------------

3.0L

5d74b17.jpg

Posted on Dec 11, 2008

  • 7 Answers

SOURCE: We are not sure where

it could be located on the back of the firewall behind the engine, or along the frame on the rear drivers side

Posted on Jan 08, 2009

  • 10 Answers

SOURCE: Mirage Mitsubishi 2000

The fuel filter is located in the engine compartment,mounted to the firewall..Lower right hand side

Posted on Mar 14, 2009

  • 10 Answers

SOURCE: Where is the ignition timing adjustment connector?

On this car the ignition timing is controled by Engine Control Module (ECM) and is not adjustable. However it can be inspeced using a scan tool.

Posted on Mar 15, 2009

  • 7353 Answers

SOURCE: P0705 Transmission range sensor circuit

The sensor should be located where the shifter cable is attached to the trans. It will have a plug with several wires. Usually there will be a way to align it, like a hole with a pin when it should be in neutral.

Posted on Jan 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How many o23 sensors in 1999 Mitsubishi mirage


On the 1.8L there is one located on the exhaust manifold and one located right behind the catalytic converter. Sensor 1 is on the manifold and sensor 2 is after the converter.

Feb 10, 2015 | Mitsubishi Cars & Trucks

2 Answers

How do i find the instument cluster for a 1997 mitchubishi mirage


Are you wanting a new 1? Or just location?
The location is right behind the steering wheel. That's the speedometer, temp gauge, batt, oil pressure, tach, and fuel gauge.

Dec 31, 2012 | 1997 Mitsubishi Mirage

1 Answer

Where is the fuel pump location on a 1997 mitsubishi mirage?


The fuel pump is located in the fuel tank. You MUST drop the tank to see and replace it.

Oct 05, 2011 | 1997 Mitsubishi Mirage

1 Answer

Fuel gauge reading half with full tank on 1997 Mitsubishi Mirage


It is a fuel gauge sensor also known as the level sensor, There is a level sensor that has a boot spring attached to it that is probraly jammed, or just simply damaged. This will need to be replaced, you can located this at your fuel pump, which in normal case is underneath you rear seat in which side is your fuel door is located. Once you located the opening of the fuel pump passage then there is normally 6-8 small bolt that is screwed to hold your fuel pump to the fuel tank and some cable harness. Theses will need to be taken off in order for you to take your fuel pump. In my best advice, you minus well replace your whole fuel pump system to save time and complication when installing

Jan 21, 2011 | 1997 Mitsubishi Mirage

1 Answer

Locate and replace ckp


It depends on if you have the 1.5L engine or the 1.8L engine. The 1.5L engine has a crankshaft Position sensor located tothe right of the crankshaft pully on the front of the engine. On the 1.8L engine the sensor is located under the timing cover.

Dec 27, 2010 | 1997 Mitsubishi Mirage

1 Answer

Where is the intake air tempeture located


It will be either screwed into the int manifold, or inside the MAF (Mass Air Flow) sensor. The MAF sensor will look like a box between the air filter and the engine. If its inside the MAF sensor, you must replace the whole MAF sensor.

Jan 16, 2010 | 2001 Mitsubishi Mirage

2 Answers

2001 mirage 1.5 camshaft sensor where is it located?


Sometimes, is necesary remove the valve cover for access to the camshaft.

d4d8222.jpg

Fig. Camshaft Position
(CMP) Sensor location

Hope helped with this (remember rated this help) Good luck.

Nov 05, 2009 | 1996 Mitsubishi Mirage

1 Answer

Locating where the starter is on a mitsubishi


passenger side top of motor behind the intake manifold if its a 1.5 motor

Aug 01, 2009 | 1994 Mitsubishi Mirage

1 Answer

2001 Mitsubishi eclipse failed smog erroe code came up Manifold Differential Pressure Sensor Circuit. where is thie located at in the engine?


2.4L
7ee7958.jpg

----------------------------------------------------------------------------------------------

3.0L

5d74b17.jpg

Dec 06, 2008 | 2001 Mitsubishi Eclipse

Not finding what you are looking for?
1997 Mitsubishi Mirage Logo

Related Topics:

137 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...