Question about Cars & Trucks
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
the link for the 4wheel drive pops off the trany, get under the jeep and push it back in,, you may need to get a new clip,, not hard to do
Posted on Apr 02, 2010
Your central processor is erratci and givng into wrong commands. Start from exiting one by one from the battery of the remote to the main hand rest., Check for poor connection in the wiring harness specially in the areas of the door hinges where the wires go into the customer control.Also try to find out if any moisture or oil has clogged on to the main Unit.
Hope you have patience.
Posted on Jun 28, 2010
Either the oil level is very low or the engine bearings have failed (assuming the gauge is accurate) if the engine isn't making noise and the level is full have a mechanical gauge installed to check actual pressure. if good, the sending unit or gauge is faulty.
If in doubt, do not drive or run the engine 'tll the problem has been diagnosed.
Posted on Feb 05, 2011
Tips for a great answer:
Feb 08, 2017 | Toyota Cars & Trucks
Jul 06, 2016 | 2001 Toyota Avalon
May 19, 2016 | Cars & Trucks
May 19, 2016 | Toyota Cars & Trucks
Mar 08, 2014 | 1998 Toyota MARK II
Apr 14, 2013 | Toyota Cars & Trucks
Jun 28, 2010 | 1998 Toyota Camry
Oct 22, 2009 | 1989 Jeep Cherokee
81 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: