Question about 2003 GMC Yukon

1 Answer

Radio in 2003 GMC Yukon isn't working

I recently replaced the battery and the radio has not functioned since. Pushing any button turns the buttons' backlight on for a few seconds. The clock comes on if I push the clock buttons. The radio does not say "locked" or anything to that effect. Also, the speakers do not work, as the "door open/key in ignition" chime and "low fuel" chime does not sound. I have been unable to find any broken fuses.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • GMC Master
  • 601 Answers

Even though it doesn't say locked, it probably is. Check your driver's manual to see how to reset it.

Posted on Jul 01, 2017

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 197 Answers

SOURCE: 1999 GMC Suburban. no sound from radio

there is a plug at the back of the radio connecting it to the vehicle wiring loom. If you can get at thes plug, either from below or by removing the radio unit, make sure the plug is tight and secure. I can't think that the amp has gone or you would have lost all sound, so this is more than likely the problem.

Posted on Jul 11, 2009

  • 2 Answers

SOURCE: 2007 gmc yukon denali wont unlock w/ keyfob

Check the buttons.. I have an 06 Grand Prix with the Remote starter on the top and it seems that the conductor on the buttons worn out.. Take the keyfob apart, pull the rubber buttons off the chip, lick your finger and touch the place where the unlock (right side of the fob) would be. That should unlock your doors. I just did it with mine. I would just buy another fob on ebay and change the buttons out.. Hope this works

Posted on May 24, 2010

  • 436 Answers

SOURCE: 2005 gmc sierra, replaced radio

i cannot understand how you radio would work. These radios are coded throught data link to computer. the only way to get the stereo to work is to run a calibration program through the vehicle. then it should accept your new cd player. if the stereo's are the same then may I suggest you to take the radios appart and switch the parts that don't work like CD drive assembly and faceplate.but use your factory installed stereo as the main core, this should fix your isses and work fine since the calibration is for the origional factory stereo.

Posted on Oct 17, 2011

  • 76 Answers

SOURCE: Radio on but no sound and door chime not working

door chime is activatid by switch on door raido should only come on when key is in on or acc setting if key is not in all the way door chime should not come on at all

Posted on Aug 27, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

We have a 2003 yukon denali xl. we have a signal saying battery not charging. we replaced battery and alternator. still won't charge. truck goes completely dead. no lights, radio anything. what el


I'll try to help, everytime something gets replaced on these yukons, that circuit needs to be RESET ! Is there a reset button, on your steering wheel, to reset a variety of functions ? , check owners manual, or call your dealer for better advise

Feb 15, 2013 | 2007 GMC Yukon XL Denali

1 Answer

Lost power in engine, engine light on traction on and radio and gauges dont work , battery keeps draining on a 2003 gmc yukon


If there is no power in your car more than likely it has to do with your car battery being dead try and jump it. Good luck!


--------------------------------------------------------------------------------------------------
GM Tech2 GM Diagnostic Scanner With C card

Dec 18, 2012 | 2003 GMC Yukon

1 Answer

Y radio display said


after market stereo i presume?
it sounds to me like the radio itself is defective if the functions are not doing what they are supposed to, pressing BAND on the radio should not switch it to blue tooth or phone, i would unplug the radio until you can get it repaired, taking out the radio fuse will still leave the memory wire hot.

Oct 12, 2012 | 2003 Chevrolet Cavalier

1 Answer

My son was playing and after I turned my radio on in my car it wouldn't produce any sound but everything else is coming on fine .Is there a mute button. Or something its a 2003 Yukon gmc factory...


I had this problem at the shop a few months ago and was able to repair it by just reprogramming the radio.I work at a .m.Dealership.I have also had to replace a radio for this same problem.This programming has to be done at a dealership.It can`t just be done at any repair shop.There is actually a bulletin for this problem.Takes about a half hour.If the programming does not work then the radio will have to be replaced.The new radio will have to be programmed also.It has to be programmed to your vehicle identification number.Hope this helps.Good luck.

Nov 14, 2011 | 2003 GMC Yukon

1 Answer

Hello, my Vibe 2003 year modle's radio or clook isn't working, a light went out in it and i tried to fix it. I worked on the fuses for awhile but now the whole radio or clook dosnt work, i can turn...


it sounds like either you need to pull radio and reconect outside of vehicle on different power source or replace check for power at fuses first.

Aug 21, 2011 | 2003 Pontiac Vibe

1 Answer

My stereo says lock what is the code 2 onlock it it's a 2003 gmc yukon XL


{: ) It's either you shoud have the Radio VIN releaarned by a scan tool, or you may need to reprogram the radio using GM's SPS programming.

Jun 21, 2011 | 2003 GMC Yukon XL

2 Answers

2003 GMC Yukon Denali My passenger side windows, locks, and mirror are not working...I am sure its a fuse but is unsure of the fuse location.


How to fix the steering wheel options on my steering wheel, for instance the volume for radio, onstar, etc? I have a '03 gmc Yukon denali xl

Jul 15, 2010 | 2003 GMC Yukon XL

1 Answer

2003 Yukon Denali, all radio functions work...just


The built in power amplifier has gone bad and needs to be replaced. You can have the radio repaired, which is cheaper then replacing it. It's common for the OEM radio on the GM to go bad as they draw high current and the heat causes the problem. Good luck and keep me posted.

Jan 12, 2010 | 2003 GMC Yukon Denali

3 Answers

Volume in 2003 yukon denali quit working on radio,


check your manuals guide book on reprogramming the radio and where would you find the fuse for the radio first check the fuse then reprogram if this information has been helpful please let us know good kuck

Jul 28, 2009 | 2006 GMC Sierra Denali

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...