Question about 1992 Ford Ranger

3 Answers

Truck wont start just clicks.

Ive got a 92 Ford Ranger 2.3L 2wd that wont start. when you put the clutch in and turn the key it just clicks. so i went out and replaced the battery cables, battery, soleniod relay (on fire wall) ,and starter, but my truck still wont start just clicks like it did before. i just dont get it. Any ideas or clues. THANKS; HANK

Posted by on

  • 1 more comment 
  • twstanley Mar 11, 2009

    every now and then. Sometimes you had to do that little gas trick where you spray it into your intake then it would fire up everytime.

  • jeffreyzales May 04, 2009

    yes,itran fine,its auto trans w/new tranny,already checked bat&connectionsRE:92ranger just click once

  • Anonymous Mar 19, 2014

    ive switched out the coil but im not getting any power to it. the battery is reading though!

×

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Yes. Ive tryed battery relays now what

Posted on Dec 28, 2015

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

After 2 weeks of searching and testing and fault elimination as I could not start my Ranger, I found that it was the bonnet release module that had gone faulty. I could turn the engine, but the glow lamp in the dash would turn of immediately when turning the key and the engine would not start. I took the unit out and turned it upside down it now starts first time.

Posted on May 03, 2013

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,055 Answers

Either a bad body ground,or your tranny is locked up,did it run good before you shut it off?

Posted on Mar 11, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 Ranger new battery new solenoid new starter. Can roll it and pop the clutch, but key wont start. Everything turns on but no click when I turn the key.


Hello

I had the same problem with mine. It ended up being the neutral safety switch connected to the clutch pedal. At least with mine you had to hold down the clutch or the truck didnt think it was in neutral. No neutral means it wont start.

I hope that helps

Nov 25, 2010 | 1996 Ford Ranger SuperCab

1 Answer

92 ford ranger i was coming home and everything was fine but it went off and it wont start again


this could be from a number of things. if it ran until you turned it off, chances are it needs a new battery because the alternator would have supplied the voltage while the truck was running, but once you turn it off, there's no juice left in the battery to start it back up again. check the dc voltage on the battery. if it's below 12 after the truck has been off for at least a half hour, replace it. to test the alternator, have the truck running anywhere between 1,000 and 2,000 rpm's and turn on ALL accessories. put the ac on max, turn on the rear defogger if you have it, turn on the radio, (it doesnt have to be turned up all the way) turn on the lights, high beams, and hazards and check the voltage at the battery. you dont want it to be below like 13v dc. also check for any A/C voltage. there should be none. if there's any A/C voltage, or the DC voltage drops below 13V, replace the alternator.

Feb 09, 2010 | 1992 Ford Ranger

1 Answer

I have power but my 1990 ford ranger clicks loudly and wont turn


Starter could be stuck..
If you are SURE you battery is fully charged with no dead cells..
Try --
(takes 2 peopl) -
Turn the key like you are trying to start it.
At the SAME time - smack the starter with a small hammer not too too hard..
Let me know what happens..

Jul 09, 2009 | 1998 Ford Ranger SuperCab

1 Answer

Fuel pump


your fuse might be loose?

Jun 16, 2009 | 1992 Ford Ranger

2 Answers

Fuel pump wont come on


bad ground wire? worst case you can run your own swicth to the pump but this woud be run off the ignition so the key must be on . is it in your tank or exturnal on the frame of the truck?

Jun 16, 2009 | 1992 Ford Ranger

2 Answers

1992 Ford Ranger - Starts Sometimes.. New Clutch. Help?


take back to dealer and have them check the neutral safety switch on the clutch because if the switch is not adjusted properly you will have this problem

Jan 01, 2009 | 1992 Ford Ranger

3 Answers

Stuck in 5th gear


try bleeding your clutch

Aug 19, 2008 | 1991 Ford Ranger Supercab

Not finding what you are looking for?
1992 Ford Ranger Logo

Related Topics:

933 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...