Question about 1990 Ford Bronco II

1 Answer

I have a 1990 Ford Bronco II that will crank, but will not start. It was running fine yesterday, but today will not start.

Posted by on

  • Anonymous Mar 21, 2014

    bronco starts and dies ht circuit

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 124 Answers

Spray starting fluid in the intake. if it starts it's fuel problem, if it does not it's electrical. could be bad fuel pump or crank sensor

Posted on Mar 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Acceleration and/or fuel problem ??


Check your Fuel Pressure. You may have a bad pump or the intake sock is plugged.

Jun 16, 2014 | 1990 Ford Bronco II

1 Answer

1990 Ford Bronco II manual transmission extremely hard to shift will not go into reverse


90 Ford Bronco II: You have to put it in whichever gear you want it in before you start it or it wont shift at all. Then once you are going its extremely hard to shift into the other gears. Reverse is the only gear that sounds like its grinding.

Aug 16, 2013 | 1990 Ford Bronco II

1 Answer

1984 Bronco ii


starter silanoid feeds power to the coil after start up giving 9 volts could be giving to much voltage check with volt meter while running

Aug 27, 2012 | 1984 Ford Bronco II

2 Answers

1990 Ford Bronco II After running a little bit starts bogging down. Have put a fuel filter on. did have bad gas


need to remove tank and clean rust and junk out of it its sucking up on the sock in the tank and blocking fuel flow

Feb 15, 2011 | 1990 Ford Bronco II

1 Answer

1986 FORD BRONCO II - CRANKS BUT NO START - NO SPARK - REPLACED IGNITION MODULE AND HALL EFFECT SENSOR, ALSO TRIED A NEW IGNITION SWITCH. HELP


I just had the same problem, today, check the tan- lt green wire on the fuel relay that is located on the right fender, mine wasn't pushed in all the way, this wire shut down spark and fuel

Mar 01, 2010 | 1986 Ford Bronco II

1 Answer

1990 full size bronco, won't start


check to see if you are getting fuel to the carb. if you have fuel then check to make sure you have spark

Nov 22, 2008 | 1990 Ford Bronco II

3 Answers

Need 2 get truck started


I had a geo metro that sat a long time and the gas turned to varnish. You will need to drop the tank, clean out the gunk, put in a new fuel pump and and filter and flush the fuel lines out to the injectors.

Sep 05, 2008 | 1990 Ford Bronco II

Not finding what you are looking for?
1990 Ford Bronco II Logo

Related Topics:

330 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...