An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: how to change starter on 1994 jeep wrangler
Remove bolts that attach starter to bellhousing. remove any brackets on nose or body of starter that attach to the block (if any) Remove wires on solenoid. Reverse to install. Before starting work, remove battery cable from battery. If your radio has an antitheft code make sure you know it before doing anything.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
i answered it finally, in 1 of your 3 posts.
with FSM pages, and step by step tests.
the circuit is very very simple.
battery >>> fuse> 5sp-rev-switch>>>lamps>>> ground.
a voltmeter finds this is 5min work.
I have tried many times to write detail step by step instructions but this site limits the size of the response to the point that I have to break it up to several parts that confuses people. So please forgive me for redirecting you to another site with the answer.
your flywheel is probally missing teeth. Take a socket and put on the crankshaft pulley and turn it about half a turn. Then try to start it,it should start. If it does or tries you will need another flywheel.
On most, you need to remove all bolts around the perimeter of the pan, (You may want to remove starter to get to fasteners there) then slide a paint scraper between the pan and block to break the seal. Generally there is enough room to get the pan out. If you need a bit more room, support the transmission with a jack (use a piece of plywood on top to avoid bending anything) remove both engine mount through bolts and raise engine slightly (not too much or you will break something)