Question about 1989 Chevrolet Corsica

1 Answer

My turn right turn signal stays solid till i pull the turn signal forward towards me and hold it thats the only way it will flash and my brakelight wont work on the right side either tried changing the brake light bulb and it still wont work

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

May be the contacts in the switch, the brake lights and turn signals use the same circut on many vehicles

Posted on Mar 10, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Brake lights rear blinkers quit working when turn signal is on flashes really fast


You simply have a burned out bulb or bulbs. With the key turned on turn on the directional for the left side and then the right side. Typically one bulb is blown and the opposite side works normally. Observe the normal side and note which is the flashing bulb. It is the flashing bulb on the other (malfunctioning) side that needs to be replaced. To replace the bulb you must remove the entire brakelight assembly, which isn't difficult. Open the trunk and locate the electrical harness that lines up with the brakelight assembly. Near the harness, locate the two (possibly three) nuts or wingnuts that attach the brakelight assembly to the car. Once the nuts are removed, the assembly can be pulled off the rear of the car. After replacing the bulb, be sure to test the operation of the new bulb before reassembling everthing.

Mar 18, 2015 | 2002 Ford Taurus

1 Answer

Is Blue Lite For High Beam Supposed T oStay on when clicked?


To clarify, when you pull the turn signal lever towards you, the high beam lights will come on only as long as you hold the lever up. This is the flash to pass feature.
To switch the headlights from low beam to high beam, you push down on the lever towards the dash. Then the high beam lights and the blue indicator light should stay on.

Jun 09, 2013 | Cars & Trucks

1 Answer

My right turn signal isn't working correctly. When I'm driving down the road my dashboard indicator for my right turn signal will turn solid green but wont flash, But when i turn my...


I had the same problem on a 92 & 95 Dakota years ago, replaced the turn signal switch in the column & found a loose ground wire in the harness back by the tail lights. Never had a problem again. If you're gonna try to replace the switch you will need tamper proof torques bits just FYI. Good luck. Let us know how it turns out.

Nov 07, 2012 | 1995 Dodge Dakota

2 Answers

My right rear turn signal stays solid, won't blink, in the vehicle the right blinker light blinks excessively fast, I have a 1999 surburban


Sounds like a bad ground to me, although i am no expert.
i would be checkinh all connections and take it from there, a little wd40 might just solve it short term.

Nov 26, 2011 | 1999 GMC Suburban

1 Answer

Right forward and rear turn signals stay on solid even with key off and out


YOUR CAR USES A ELECTRONIC TURN SIGNAL FLASHER .IT CONTROLS THE 4WAY AND TURN SIGNALS SOUNDS LIKE THE FLASHER CONTACTS ARE BURNED FAST .REPLACE THE FLASHER UNIT.

Jan 09, 2011 | 1996 Ford Explorer

1 Answer

I recently put a new alternator in my 1995 camaro. Now when i turn over the key the security light comes on and stays on solid (not flashing) The car won't start. I already tried bypassing the vats with...


The problem is your Vats security system. This causes the car to either "not start" or "shut down" while running. (depending on the system) If the security light flashes, i guarantee that this is what the problem is. 1st trick, turn the key forward 2 clicks till right before it would normally start, leave like that for 10 minutes. ( no less ) After 10 minutes, turn key back then forward and your car might start. Cheap fix: ----- http://vats.likeabigdog.com/ ----- Bypassing the key Never worry again fix: -------- http://newrockies.ca?ap_id=judd0081 ----- With this fix, you can take that whole Vats, passlock, passkey **** system out of your car all together. Good info on both sites

Nov 29, 2010 | 1995 Chevrolet Camaro

2 Answers

Turn signal makes the dash lights flash


97 chevy blazer left turn signal makes the dash lights flash then when i turn parking lights on left signal stays on constent when engaged

Jan 16, 2010 | 1995 Chevrolet K1500

1 Answer

How to change the turn signal flasher?


Check the the bulbs at the front and rear of the vehicle work. If one is not lit up, replace that one. On some of the earlier model cars the blinkers would stay solid and not flash when one or both bulbs were blown. Modern cars have a rapid flash when one or both are blown

Nov 24, 2009 | Oldsmobile Cutlass Supreme Cars & Trucks

2 Answers

Right turn signal not flashing on 1992 Buick LeSabre


I know this will sound Stupid. Get back inside to the Bulb that you Replaced and Turn it Over. Some of these Bulbs will only work if they are in a Certain way. Have that Side Blinker Going when you are Messing with the Bulb to Minimize the Work load on thisPlease Rate my Response, I need all the Help That I can Get! Thanks! Job.

Jan 27, 2009 | 1992 Buick LeSabre

Not finding what you are looking for?
Cars & Trucks Logo

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6869 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...