Question about 2001 Chrysler 300M

1 Answer

Gas pump keeps shutting off when fueling

2002 chrysler 300M
cannot fuel car without the pump shutting off, you have to litterally click the pump every two seconds no matter how slow you try to go. Had the tank removed all lines and vents checked and anti siphon checked, tried several different pumps at several different stations. ideas?

Posted by on

  • Yimmy Mar 12, 2009

    The dealer sold me a vapor solenoid located in the canister attached to the gas tank, it has a built in solenoid that vents the tank. $336.00
    problem solved. He also told me that starting in 2004 on all 300's this solenoid is incorporated into the fuel pump assembly.
    Thanks for your time.


×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 4,369 Answers

You have a vapor vent issue. The fuel filler pipe has a vent inside of it to let out air as you pump gas in. If no air comes out, it will kick of the nozzle
The other possbility is that it is a poor design and others are having issues too. Cal your dealer service manager, not a service writer and ask him if there is an issue. Write or email Chrysler and ask them too. If the fuel filler pipe has a sharp bend and goes up hill at all, that will back up the fuel fill. Try putting the nozzle in upside down & see what happens. Also, try inserting the nozzle just a couple of inches. Report back please.

Posted on Mar 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace the fuel pump in a Chrysler 300m?


  1. Disconnect the Battery
  2. Drain the fuel from the Tank
  3. Raise the rear of the car and support with 2 jack stands
  4. Remove the Tank
  5. Remove the Old Pump
  6. Install the New Pump
  7. Reinstall the Tanks.
How to Remove and Replace Chrysler 300 Gas Tank And Fuel Pump

May 05, 2016 | 1999 Chrysler 300M

1 Answer

My Chrysler 300m 2002 wouldn't start found out the battery was corroded and replaced the battery tried to start it but it wouldn't turn over it seems it wants to start but want thought maybe to put some...


Easy way to find out. #1 take some starting fluid, a very short 1 or 2 second squirt into the air intake tube by the air filter. see if car starts. if it does it could be the pump or the fuel pressure regulator or maybe your not getting spark to the coils. #2 take a big rubber mallet and while some turns the engine over whack the bottom of the gas tank real hard (Rubber mallet). if the pump kicks on and the car starts then you have a bad fuel pump. #3, find the schreader valve on the end of the fuel rail, turn key to on position, press the schreader valve, if gas flies out then your pump is working.

Oct 28, 2013 | 1999 Chrysler 300M

1 Answer

How do you replace the fuel pump/filter im a 2002 Chrysler 300M?


Here's a link on how to replace fuel pump.Here's the fuel filter repair guide.

Dec 13, 2012 | 2002 Chrysler 300M

1 Answer

Where is the fuel pump in a 1999 300M Chrysler? I ran out of gas and do not know how to reset the fuel pump nor do I know where it is.


The fuel pump is in the gas tank. You shouldn't have to mess with the fuel pump if all you did was run out of fuel. Simply fill it and start it. Should take a few tries to get it going since the fuel has to travel to the engine, maybe two to three cranks. Put the gas pedal all the way down to the floor and try it, let go as soon as it starts.

Jul 28, 2011 | 1999 Chrysler 300M

1 Answer

Is there an access panel to the fuel pump on a 2004 300m?


On your car there is an access panel in the forward part of the trunk that will let you get to the fuel pump without dropping the gas tank!

Pull back the carpet in the area between the rear wheels, thats the access panel! good day !!

Jun 21, 2011 | 2004 Chrysler 300M

1 Answer

Chrysler 300m wont start changed fuel pump. Was acting like it wanted to start before i changed the fuel pump, with starting fluid. the car acts like its going to start but wont. The relays have been...


What prompted you to change the fuel pump to begin with? Did you check the codes on the dash? Or have someone OBD check it? It could be a crank sensor, but the codes should reveal that. Codes first and work backwards, please.

May 27, 2011 | 1999 Chrysler 300M

1 Answer

Car turns off while its being droven


COULD BE FAULTY IDLE AIR CONTROL WATER IN GAS STOPPED UP FUEL FILTER.FAULT IN THE PCM OR FAULT IN ALTERNATOR. BEST TO HAVE VECHICLE SCAN.SAVE TIME AND MONEY.MANY THINGS WILL CAUSE VECHICLE TO STALL OUT.

Jul 23, 2010 | 2000 Chrysler 300M

2 Answers

Where is the fuel pump reset button on a Chrysler 2002 300


this model dosen't have a fuel pump reset button.

Oct 15, 2009 | 2002 Chrysler 300M

3 Answers

BANK 2 SENSOR 1 WHERE IS IT LOCATED ON 02 CHRYSLER 300 M


That sensor is the one between the exhaust manifold and the catalytic converter (sensor #1). Bank 2 is the side of the engine that cylinder #1 is NOT on. Here is a diagram showing cylinder #1.

6468c66.gif

FYI, sensor #2 is the one behind (downstream) the catalytic converter.

Mar 25, 2009 | 2002 Chrysler 300M

Not finding what you are looking for?
2001 Chrysler 300M Logo

Related Topics:

542 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...