Question about 2002 Jeep Liberty

1 Answer

Gas tank is loose

When i look under the back of my 2002 jeep liberty sport..it looks as if the gas tank straps are not secure..when i wiggle them they feel loose and cannot tell where they are supposed to be secured, or what they look like when they are secured properly. Other gas tanks i have seen the straps wrap tightly around the whole tank..but in this case the straps are in a "V" shape underneath the tank.

Posted by on

  • yadayada
    yadayada May 11, 2010

    of course they are supposed to be tight, get under the truck and tighten them.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

On one end of each strap there should be a bolt. It's possible that there was an "insulator" between the strap and tank that deteriorated and fell out. It's not essential that it be replaced but likely you can tighten those bolts to take up some of the slack. Don't crank down too tight or you may distort tank.

Posted on Mar 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Horn circuit diagram for Jeep Liberty Sport 2002 Limited Edition


good luck

https://www.google.com/search?q=Horn+circuit+diagram+for+Jeep+Liberty+Sport+2002+Limited+Edition&rlz=1C1CHZL_enCA696CA696&espv=2&biw=1152&bih=547&tbm=isch&tbo=u&source=univ&sa=X&ved=0ahUKEwiz7dfx6cPNAhVD2IMKHax1CpQQsAQIGw

Jun 26, 2014 | 2007 Jeep Liberty Sport

1 Answer

How to lower gas tank on 02 liberty to inspect evap hoses?


Pretty simple process, if you have a tow hitch it will have to be removed first. Once that is done you will need to disconnect fuel lines and electrical connections. Evap hoses and fill hose and remove straps from tank. Place floor jack under tank prior to releasing straps and then lower slowly to ensure you didn't leave anything connected

Apr 11, 2013 | 2002 Jeep Liberty

1 Answer

Gas gage not working or works intermitently


Nothing Easy at all

Drop the fuel tank & replace the sending unit

Nov 23, 2012 | 2002 Jeep Liberty

1 Answer

2002 jeep liberty 3.7 liter 6 cylinder 4x4 spark plug gapage. What should it be?


Make: JEEP
Model: LIBERTY - SPORT
Year: 2002
Engine: V6 - 3.7L - FI - - GAS

Part Number RC9MC4 .044" (Original Equipment Manufacturer and/or Original Equipment Equivalent)

Hope helps (remember to rated and comment this).

Sep 12, 2010 | 2002 Jeep Liberty

2 Answers

I need the location on where the fuel filter is located on a 1998 dodge caravan sport 3.3L flex fuel.


I believe the fuel filter is under the vehicle and over the fuel tank. You'll have to drop the tank to access the filter. Loosen the nut on both ends of the filter and gently seperate. Replace new filter and retighten the nuts. Secure the tank back.

Put a jack (for a flat tire) under the fuel tank, so you could control how far it dropped. Then remove the two screws that hold the fuel tank straps. The screws come out, the fuel tank is loose, lower the tank by lowering the jack. Now it is easy to reach the filter. One screw holds it in place. Unscrew it, it comes right out. The tricky part is figuring out how to unplug the fuel lines. Look at the replacement filter, note how the plastic piece inside each fuel line has to be squeezed to remove it. You need to squeeze the old ones the same way to release them. It isn't easy. Squeeze the plastic piece that is holding the hose in place until you can work it out. A few drops of gas will dribble out. The gas is NOT pressurized. Unsnap the old hoses, snap in the new ones (much easier). Screw the new filter into place. Jack the fuel tank back into place. Screw the straps back on. Clip the ground strap in place where the old one was. You're done.

Aug 03, 2010 | Dodge Caravan Cars & Trucks

1 Answer

Replacing mirror 2002 jeep liberty


three 10mm nuts hold mirror on under bezel small set screw bottom of bezel along with a philleps screw can sometimes wiggle bezelupwards and you can remove without removeing door pad.if pad must be removed loosen screws by door handle arm rest look for plugs with small screwdriver remove plugs and screws tap pad upwards with hand reverse procdure to complete.

Nov 22, 2009 | 2002 Jeep Liberty

1 Answer

I just purchased a 2007 jeep liberty sport


I have a 2005 Jeep Liberty and the smae lever that tilts the seat also moves it forward and back. Press forward or back on the switch. Also check for blown fuse or a loose wiring connector under the drivers seat. Good luck, Techjoel

Jun 07, 2009 | 2007 Jeep Liberty Sport

Not finding what you are looking for?
2002 Jeep Liberty Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...