- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hi, if you finf your car fuse bos only way is to test them one one. If you find one not bring light tester on pull out and check it. On th fog light is plug connection check if is power on that wires. if not something wrong with your switch doesn't open circuit to the plug wire for the fog light.
if fuses are good and bulbs are good,it has bad grounds or the switch is failing,use voltmeter and ck for voltage at the bulb wire connections,if no voltage ck at switch end.if voltage present at switch then ck wiring between switch and bulbs.good luck
Try under the hood near the right side of the car. There are also a couple of fuse boxes with fuses for things under the motor bonnet in the rear. They should be labeled and they are covered with black covers. Hope this helps.
The 15 amp FOG fuse is in the fuse box in the engine compartment, at the bottom, right between the fog light relay and the fan #1 relay. The fuse is by itself, there are no other fuses next to it. Hope this helps, and thanks for choosing FixYa.
on each headlamp assembly, there will be either one or two plastic nuts that you can turn.
If you only have one nut on each, that will adjust the vertical aim of the headlights.
If you have two nuts on each, one will adjust the vertical and the other will adjust the horizontal.
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.