SOURCE: clutch kit for mazda b 2500 drifter 4x4 diesel d/cab
http://jdmultimate.com/Store/Product/ItmItem.aspx?ItemId=176995&Make=MAZDA&Model=B2500
There you go if you need anything else let me know. I hope you find this appropriate for a FixYa rating.
Thanks,
Lee
SOURCE: I need the cylinder head torque settings
4 steps, starting from center and doing the normal pattern. 30 ft lbs, then 44 ft lbs.
3rd step 1/4 turn
4th step addional 1/4 turn. Make sure you are using new bolts.
SOURCE: Hi I'm looking for cylinder head torque settings for a 1992 BMW 316/318 e36
BMW cylinder torque setting all models
According to my service manual as follows.
Cyl head to engine block (torx e12 M10 bolts)
Stage 1 30nm (22 ft – lb)
Stage 2 + 90 degrees
Stage 3 + 90 degrees
Cyl head to lower timing chain cover 10nm (89in – lb)
The tightening sequence is from inside to outside crossover as normal. Loosening sequence is from outside to inside crossover. Remember to set torque wrench at low setting and work gradually up through the whole sequence until you get the desired torque.
SOURCE: 94 mazda B3000 3.0L cylinder head torque specs
Step 1 torque to 59 ft pounds
2. Loosen one full turn
3. 37 ft pounds
4. 68 ft pounds
Use torque sequence below
SOURCE: How do you set engine timming Mazda drifter 2.5TDI
I want kow timing order in mazda drifter petrol engine
Fig. Tighten the exhaust manifold bolts in 2 stages
To install:
633 views
Usually answered in minutes!
×