Question about 2003 Chrysler Town & Country

Open Question

2001 town & country van. My rear windshield wiper will not work.

I do not have the owners' manual to see if there is a fuse for this unit or if the motor is shot.

Posted by on

5 Suggested Answers

c17hydro
  • 2984 Answers

SOURCE: my 2001 Town and Country's rear windshield wiper

Pretty straight forward.....here are the steps:

Please don't forget to rate--

Rear Window Wiper Motor Removal & Installation To Remove:

  1. Disconnect and isolate the negative battery cable.
  2. Remove the rear wiper arm.
  3. Open the liftgate.
  4. Perform the following to remove the liftgate trim panel.
    • If equipped, remove the lift motor link
    • Remove the upper frame molding
    • Remove assist handle screws
    • Disengage the hidden clips around perimeter of liftgate trim
    • Disconnect the electrical connectors.
  5. Disconnect the wire connector from the wiper motor.
  6. Remove the wiper motor mounting screws.
  7. Remove the wiper motor.
To Install:
  1. Position the wiper motor in the liftgate.
  2. Install the wiper motor mounting screws.
  3. Connect the wiring connector.
  4. Install the liftgate trim panel.
  5. Close the liftgate.

Posted on Jul 24, 2009

  • 7353 Answers

SOURCE: Windshield wipers flop all around, go right off

You may have bushings bad, but I dont know if you can buy those seperate, or the whole wiper transmission.

Posted on Dec 30, 2009

  • 1206 Answers

SOURCE: rear windshield wiper blade doesn't hit rear

the pivot pin must be rusted to the point it does not want to move, try lubing it with wd40 or equivalent lube,at the bottom of the wiper arm just before the bolt that holds it to the car is the pivot point.that's where it has to be lubed.

Posted on Jan 18, 2010

Testimonial: " Thank you for the information. Will give it a try."

  • 1 Answer

SOURCE: where can i find a owners manual for 2001 chrysler van

1-800-890-4038
M-F 8:00AM-8:00PM EST

Posted on Mar 13, 2010

  • 1509 Answers

SOURCE: replace rear bumper 2001 town and country van

Depends on how baddly the whole car is bent and how much you pay your self. You can do it, and if it's bent bad enought that you can't expect to pay mor than flat rate anyway because thier not just changing the bumper cover and or the bumper core and or the bumper core supports and or painting the new bumper cover and or replacing or straightening the care and even pulling the frame.. Most body shops and dealers will estimate this job but they have to see it because of the stroy I just told. They most often estimate for free as your insureance companies adjuster wight also. They may even come to your work or home to see the problem. If you want to keep the insurance man out of the loop then go to an auto parts store that sells auto paint and supplies. They'll tellyou about their customers and what to expect from them. and you'll hear alot of different prices, including look good or look good and be good and strong, all the prices wil be different.

Posted on Jul 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the location of 2001 town and country located


The fuse box under the hood should be next to the battery. There is also a fuse box inside the van. Your owners manual should show the locations of both.

Dec 12, 2012 | 2001 Chrysler Town & Country

2 Answers

On my 02 town and country i have a warning light that i dont know what it is. i do not have an owners manual. it looks like the button for the rear wiper. it is located on the lower right side.


Almost sounds like a washer light.
Check your windshield washer fluid.
If empty, fill it and see if light goes away.
Otherwise, sorry I wasted your time!

Jan 05, 2011 | 2002 Chrysler Town & Country

1 Answer

Fuse for windshield wiper motor


It may be the windshield wiper module instead of being the motor, since you have had that replaced 3x already. There should be no fuse issue.

Jul 18, 2010 | 2001 Lincoln Town Car

1 Answer

Windshield wipers flop all around, go right off the glass not in unison. 2001 Chrysler Town and Country.


You may have bushings bad, but I dont know if you can buy those seperate, or the whole wiper transmission.

Dec 30, 2009 | 2001 Chrysler Town & Country

1 Answer

Front windshield wipers are crashing into each other


Yes you can adjust them yourself. First you need to check that the wiper arms are not bent. If not, remove the cap at the wiper arm base, under it u will find a nut, remove this nut. you should now be able to remove the wiper arm. (it is comon for caravan wiper arms to be corroded on. If the arm dosen't come off, you may need to heat up the wiper arm with a propane torch. be careful not to melt the plastic cowel under the arm. OR you can use a wiper puller or a battery puller. do not force it, you can break the arm, DO NOT PRY AGAINST THE COWEL OR WINDSHIELD.
Once both arms are off, turn your van on and turn the wipers on. watch the wiper posts, turn the wipers off and watch the wiper posts return and stop in the "parked" position. Turn the van off. Install the passanger wiper arm first, it is positioned closest to the bottom an inch or two above the black cowel. It should be parrallel to the cowel. next install the drivers side wiper arm. it is positioned about 4 inches above the passanger wiper. again running parrallel to the cowel and passanger wiper. tighten the lock nuts down (do not over tighten) wet down your windshield with glass cleaner or windshield washer fluid and test wipers. If they still hit you can lower the passanger one a little or raise the drivers one a little (careful you don't raise the drivers one too much or it will 'jump' off the windshield at the top of the wipe).
good luck, hope this helps.

Nov 23, 2009 | 2001 Chrysler Town & Country

1 Answer

My 2001 Town and Country's rear windshield wiper motor is kaput. How do I change it without destroying the rear tailgate paneling


Pretty straight forward.....here are the steps:

Please don't forget to rate--

Rear Window Wiper Motor Removal & Installation To Remove:
  1. Disconnect and isolate the negative battery cable.
  2. Remove the rear wiper arm.
  3. Open the liftgate.
  4. Perform the following to remove the liftgate trim panel.
    • If equipped, remove the lift motor link
    • Remove the upper frame molding
    • Remove assist handle screws
    • Disengage the hidden clips around perimeter of liftgate trim
    • Disconnect the electrical connectors.
  5. Disconnect the wire connector from the wiper motor.
  6. Remove the wiper motor mounting screws.
  7. Remove the wiper motor.
To Install:
  1. Position the wiper motor in the liftgate.
  2. Install the wiper motor mounting screws.
  3. Connect the wiring connector.
  4. Install the liftgate trim panel.
  5. Close the liftgate.

Jul 24, 2009 | 2001 Chrysler Town & Country

1 Answer

2001 lincoln town car winshjield wiper


where is the fuse box for my 2001 lincoln towncar looking for windshield wiper fuse because they wont turn on what so ever

Mar 07, 2009 | 1997 Lincoln Town Car

1 Answer

Windshield wipers


From your owners manual:

Fuse#11 30A , Wiper Run/Park
Relay, Wiper Hi/LO Relay, Windshield Wiper
Motor, Rear Washer Pump Relay

U will also need to check the relays if the fuse is ok, the relay, it is the underhood fuse box
Relay #202 — Front Wiper Run/Park Relay

Dec 18, 2008 | 2001 Lincoln Navigator

Not finding what you are looking for?
2003 Chrysler Town & Country Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...