Question about 1998 Jeep Grand Cherokee

1 Answer

1998 grand cherakee driver side cv joint removal

I need to know how to get the drivers side cv joint off on my 1998 grand cherakee

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

You can find instructions for doing this in any half decent manual. One thing they usually don't tell you is when removing the large axle nut on the end, it helps to put a spare tire on with no center cap and with the vehicle on the ground, break that nut free before starting the job. without air tools, it's next to impossible to remove it when jacked up.

Posted on Mar 10, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What tools other than sockets and rinches will i need to change driver side cv joint on my 98 ford escort se no abs single ohc


There is a CV Joint pulling tool you will need. and make sure you have "deep well" sockets

May 23, 2011 | 1998 Ford Escort

1 Answer

Need diagram on what has to be removed to replace the driver side trans axle


Not much to it,
remove wheel,remove axle nut,remove bolt and nut that pinch lower ball joint in place,it will either be an 18mm or a 21mm,pry lower control down to detach and separate ball joint,tap CV shaft in where you took the nut off,
hold out on rotor assembly while pushing CV shaft in ward,When you have the CV out of the bearing and rotor assembly,Tap inside CV joint out of transmission.

Dec 16, 2009 | 1996 Plymouth Grand Voyager

1 Answer

Clicking, sticking sound from front end, drivers side


It is your cv joint that is bad. If you jack the van up on that side, check to see if the boot is ripped...and more than likely your cv joint is about shot...even if the boot is intact.

The cv joint is bad....


e252e40.jpg

Aug 30, 2009 | 2002 Dodge Grand Caravan

2 Answers

What's involved in changing out cv joints on a 96 grand cherokee?


the joint is fairly easy to change. the hardest part is getting the hub assembly off. you will need a36mm sokcet for the hub nut.i had to use an 18" breaker bar to remove it.

Aug 11, 2009 | 1996 Jeep Grand Cherokee

3 Answers

My front differential is leaking!


I cannot see it, but I am guessing that you need to replace your axle seal. To do this,you have to pull your CV shaft out. Remove the tire, remove the caliper from the top of the rotor. Using a hammer on the back, remove the rotor. Take off the spindle (axle) nut, separate the axle (CV shaft) from the hub. Replace seal. It should pop right out. Good luck!

Aug 05, 2009 | GMC Sierra 1500 Cars & Trucks

1 Answer

1999 pontiac Grand Am CV-Joint


Get a pickle fork. if you dont have one, you can rent one from Schucks or another auto parts store pretty cheap.

Jul 26, 2009 | 1999 Pontiac Grand Am GT

1 Answer

02yukon i cannot get the cv joint out from the wheel/brake assem


Remove steering joint.Then bottom ball joint then you should be ok.

Jul 13, 2009 | 2001 GMC Yukon

1 Answer

Ball joint nocking or strut tower


CV joint, the strut does not make a knocking sound unless its totally
shoot and the car is bouncing to its high and low limit.

If you push down on the car and it bounces a little then the strut is shoot.

The cv joint will knock if it is bad when you turn the wheel, when it gets real bad,it will knock when driving in a straight line.

Apr 07, 2009 | 2003 Pontiac Grand Am

Not finding what you are looking for?
1998 Jeep Grand Cherokee Logo

478 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...