Question about 2006 Ford Focus

1 Answer

Engine vibration at lower rpms

Engine ran smooth when new (now 45000 miles). Feel vibration when slowing down or at idle.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

Check motor mounds.or perform full tune up.

Posted on Mar 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 06 altima that smokes a little bit while


You most likely have bad compression in engine. Notorious for bad catalytic converters. Scores piston walls and fits your description. Gut out cats fill with engine restore. and start looking for a engine.

Sep 11, 2014 | 2006 Nissan Altima

1 Answer

2010 ford fusion vibration at idle and acceleration.


Chances are its a minor miss in one of the cylinders. You don't feel it neutral at idle or until the trans goes into overdrive because those times the engine is not working very hard.
If it is a miss fire the check engine light will come on when it gets bad enough to affect fuel mileage.
If you have not yet changed the plugs I would start with that. There is also a chance you damaged the engine when it overheated.

Dec 09, 2012 | Ford Fusion Cars & Trucks

1 Answer

Rough idle and code po1562


First u have to take it to ur car dealership they have scan tool the scan tool will read the fault code and tell u which part or sensor is in faulty that way it's easy fix

Jan 20, 2012 | 2001 Volkswagen Jetta TDI

1 Answer

02 zx2 75000 miles Installed 3 0f 4 new mounts but still vibrate


This engine does not have a harmonic balancer. This is the cause of the rough in gear idle with the automatic transmission.

Nov 28, 2009 | 2002 Ford ZX2

1 Answer

Idling lower than 1,000 rpms. at high speeds,


Had a firebird act similar to that had a bad coil pack replaced it the spark plugs and wires and ran fine.

Oct 13, 2009 | 2005 Volkswagen New Beetle Convertible

1 Answer

Rpms Too Low


the idle speed is controlled through the on board fuel injection control module (known as the PCM), even if u raise the idle at the throttle body the computer will slow it back down, however there is a problem that causes slow idle, do the following procedure to correct the slow idle issue, follow it exactly.

Here are some of the causes of surges, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Apr 07, 2009 | Pontiac Grand Prix Cars & Trucks

1 Answer

00 ford zx2 idles ruff in gear so bad it shakes


.how to set the timing on a 2000 ford sescort zx2 and why does it idle rought it a dual kam 2/0 timing belt broke and the engine was fixed in a shop but i dont think they know just how to set the timing right when im going up hill and the car shifts back the engine reves up to about 3000 rpms the engine sounds lick it is pinging real loud sounds like it not set right

Mar 03, 2009 | 2001 Ford Escort ZX2

1 Answer

ENGINE VIBRATION AT IDLE BUT OK WHILE DRIVING.


Could be any one, or more, of the following -

Plugged injector
Bad plug wire
Fouled plug
Crossed plug wires (hard to tell sometimes on V-8s that run smooth anyway)
Vacuum leak
Leaky EGR valve
Shifted timing sensor

Scan engine for codes and proceed from there.

There is a product called RXP (available here in Texas) that will clean up an engine and gas. Its pretty awesome stuff, and this coming from a person who doesn't really believe in additives.

Jan 24, 2009 | 1995 Nissan Altima

1 Answer

Engine shutter and lack of power


You probably have a vacuum leak somewhere. Check for broken or cracked hoses and/or plastic pieces they connect to. Pay special attention to suction pump, part# 058 133 753 B. Google it.

Nov 10, 2008 | 2002 Audi A4

Not finding what you are looking for?
2006 Ford Focus Logo

Related Topics:

196 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...