Question about 1995 Mercury Villager

1 Answer

I have a 95 mercury villager changed thermostat and now the check engine light comes on and off and when light is on it will start up fine and the cooling fan comes on when the light is on when light goes out it dont want to crank just turns over and can smell gas i can pull coil wire off and turn over the motor and have fire and put the coil wire back on and pull plug wire off and turn over the motor no fire let it sit 30 min and it will start back and have the same problem as above anybody have any ideas thanks.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 4,369 Answers

Go to this site. We can help you better there. Read files and ask our group questions.
http://autos.groups.yahoo.com/group/villagerquest/

Posted on Mar 10, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil preasure light comes on and taps like we have no oil in motor after changing front oil seal and timing belt it starts fine


Could have a bad bearing due to a faulty oil pump.Do not run the engine any more till you get it checked out,or you could ruin the engine!

Jan 14, 2014 | 1995 Mercury Villager

1 Answer

I have a 2001 mercury villager and about two weeks ago, the engine services light comes on. My heater does not get hot even when the temperature is half way up. Now, my oil light comes on and I check


Did you check your coolant level? If it gets low you won't get heat. Is the temperature getting completely up to the normal operating range? If the thermostat sticks open your engine won't get to normal range and you won't have good heat.

Jan 01, 2013 | 2001 Mercury Villager

1 Answer

I have a 2000 mercury villager runs fine when first started in the morning but after several miles stats bucking and knocking worse when you try to excelorate bogs down real bad, could this be the knock...


do not change the knock sensor.

sounds like cam sensor in distributor is going. works cold fine, then as engine warms upo it starts going. is tach needle jumping too?

Buy reman rich porter on ebay for $200. sensor inside is not serviceable. common issue on 99-00.

go here


Gerry

http://groups.yahoo.com/group/villagerquest/

Dec 30, 2010 | 1999 Mercury Villager

1 Answer

2002 mercury villager water circulation problem, engine overheats when started. Thermostat has been replaced, but no help. Does not overheat when themostat completely removed. Could water pump be the...


Check the new thermostat by putting it in a pan of water and bringing it to a low boil. See that it opens. It is possible to get bad parts off the shelf.

Jan 15, 2010 | 2002 Mercury Villager

1 Answer

95 mercury villager v.6 jolts when entering first


you need to disconnect the battery for 2 hours to clear the computer memory so it can relearn the new engine.
Also, adjust the TP, throttle position sensor with volt meter or ohm meter. clean MAF sesnor with carb cleaner.

go here for more help with villager

http://groups.yahoo.com/group/villagerquest/

Jan 12, 2010 | 1995 Mercury Villager

1 Answer

1995 Villager Engine light is on


you may have a broken crankshaft snout.This was a common problem on 93-95 Villagers if customer replaced a/c belt and overtightened the belt tensioner.

Did you ecently have the belt changed?
Also, remove distributor cap and rotor ( 1 screw) and slotted plate/ Look for brown dust on optical sensors. If yes clean them and see if van starts. If it starts you will need a new distributor (ebay $200) as the bearing is going.

more help from our villager/quest team

http://autos.groups.yahoo.com/group/villagerquest/

May 24, 2009 | 1995 Mercury Villager

2 Answers

95 Mercury Villager will not start


check/replace the starter relay switch in the relay box under the hood. The relay box is located on the front right of the engine compartment. easy fix, inexpensive part if that is the problem.

May 02, 2009 | 1995 Mercury Villager

2 Answers

Check engine light for a 1995 Mercury Villager is on


Couple of suggestions;

Phone around to some car repair places and see if they have an instrument to read/clear the codes from your '95 Villager. Some shops still have and use them.

Chances are you might need a new BPT hose. This is a very easy and inexpensive fix. My check engine light was on for about 75,000 km before I replaced the BPT hose and since then the check engine light has never come on again.

The Villager is still going strong at 375,000 km.

bikerbc

Mar 14, 2009 | 1995 Mercury Villager

Not finding what you are looking for?
1995 Mercury Villager Logo

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...