Middle Seatbelts the middle seatbelts have a begining buckle. and i have no place to plug this begining buckle into. i am not sure if i have off seats or missing floor buckles.

ok if you can see were they are bolt to the floor remove it from there and take the seat out with it,now if that seat is hold down by going in a slot and with a lever you pull or push to take out just do what you have to remove the seat

I just reached under seat and found the wire connector that comes from seat buckle end and unplugged it.

Have the same problem in my 98 Toyota Rav4. I squirted the female buckle (bolted to seat, not holding strap harness) with wannabe WD-40 lubricant from the $1 store, and it seem to have solved the problem. I'm guessing the spring mechanism is worn out, which is why the harness buckle won't lock. Another solution is to replace the female lock buckle with an identical part from the used parts junkyard store.

The seatbelt light on the dash stays "on," even when everyone has their belt on, but I don't bother servicing that. If yours have an audible alarm instead of an indicator light on the dash, locate the source of the alarm sound and disconnect the wires to silence the sound.

You can't unlock the seatbelts. They have an explosive charge built in that goes off like an airbag, locking up the belts on impact. You will have to replace all your locked up seatbelts.

if you can pull the belt out, it should go back on its own, otherwise its a new belt,its a "no fix" item.

unbolt the seats and seatbelts

hello tracieandmia, I am assuming that the seatbelt buckles are just underneath the seat. The rear seat bottem can be removed for access. If you reach under the front part of the seat bottem near each corner and lift up, the seat will release. You will need to give it a little yank and use a little force for it to release. Once each corner is released you can remove the seat bottem. To install the seat, slide it back under the seat back and push hard down on each front corner that you had previuosly pulled up at. You should hear a definite click/lock sound when the catches are locked.

you must first remove lower seat in rear seatbelts and rear seat back then can remove deck has a couple of pop plugs through panel bend in middle will come out.

I need to replace the rear passenger-side seat belt buckle clasp but the clasp (under back seat) is connected to the seatbelt for middle backseat passenger.Can I replace just the passenger side without disturbing the middle belt?, cheers,Jen.

a babys car seat?