Question about 1989 Dodge Dakota 2WD

1 Answer

I have a 1989 Dodge Dakota that the parking lights will come on while the truck is parked with the lights and ignition off.Also if the radio was left on, it also plays.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Is there a remote start system installed on this vehicle?

Posted on Mar 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I lost the fuse diagram for my dads 95 dodge grand caravan. Can anyone help me out with one?


#1: Panel Illumination
#2: Guages,Right High beam headlight and the high beam indicator
#3: Rear Wiper, Left headlight High Beam
#4: RH park, backup lights switch and relay,Speed porpotional steering module,power door lock switch illumination and daytime running lights(Canada)
#5: Power Door locks,Power Mirrors,vanity,dome,map,ignition and trunk lights,sunroof,radio,power antenna,body control module and power for the data link connector
#6:Heated mirrors,heated rear window indicator
#7: Instrument cluster illumination,park and tail lights
#8: Cigarette lighter,Radio Amp and horns
#9: Power door lock motors
#10: Not used
#11: Radio
#12:Left low beam head light
#13,14,15,16 not used
26153814-2qh1jtrzfrcszgktlooiom5o-3-0.jpg

Apr 05, 2016 | Dodge Cars & Trucks

1 Answer

Wiring diagram running light, need wiring diagram for 2006 dodge dakota ,right tail light is out but brakeand turn signal works


With a test light check if you have power there with lights on and with lights off, compare left side with right side as far as location in the tail lamp plug for the tail lamp park lights.Trace the harness back to the left side underneath usual corrosion in this area.

Aug 30, 2014 | 2006 Dodge Dakota

1 Answer

How do i remove the steering column cover to get at the ignition tumbler on a 1993 dodge dakota


CAUTION Disconnect and isolate the negative (ground) battery cable. This will disable the air bag system. Failure to disconnect the battery could result in accidental deployment and possible personal injury. Allow the system capacitor to discharge for two minutes then begin air bag system component removal. To install:
  1. Engage the electrical connectors to the ignition switch and make sure the switch locking tabs are fully seated.
  2. Before attaching the ignition switch to a tilt steering column, the transmission shifter must be in the PARK position. Also the park lock dowel pin and the column lock flag must be properly indexed before installing the switch as follows:
    1. Place the transmission shifter in the PARK position
    2. Place the ignition switch in the LOCK position. The switch is in the lock position when the column lock flag is parallel to the ignition switch terminals.
    3. Position the ignition switch park lock dowel pin so it will engage the steering column park lock slider linkage.
    4. Apply a light coating of grease to the column lock flag and the park lock dowel pin.
  3. Place the ignition switch against the lock housing opening on the steering column. Ensure that the ignition switch park lock dowel pin enters the slot in the park lock slider linkage in the steering column.
  4. Install the retaining bracket and ignition switch mounting screws, then tighten the screws to 22-30 inch lbs. (3-4 Nm).
  5. If the vehicle is equipped with a tilt steering column, install the tilt lever.
  6. With the key cylinder and the ignition switch in the LOCK position, insert the key cylinder into the ignition switch until it bottoms.
  7. Insert the ignition key into the lock cylinder. While pushing the key cylinder in toward the ignition switch, rotate the ignition key until the end of travel.
  8. Install the retaining screw into the bracket and lock cylinder. Tighten the screw to 22-30 inch lbs. (3-4 Nm).
  9. Install the steering column covers, then the tilt lever, if equipped.
  10. Connect the negative battery cable.
  11. Check for proper operation.


ec3f7ac.jpg

eff2c5f.jpg

72e2667.jpg

7a1362b.jpg

Jul 30, 2010 | 1993 Dodge Dakota

1 Answer

I have 2001 doge dakota and left ignition on and


Not sure but you may have a radio that needs a code input. the radio thinks it was taken out and a code needs to be put back in at the proper time. if you bought the truck new it should be in oners manual. if not you have to get it from a dealer. you may have to pay for it.

Oct 07, 2009 | 2001 Dodge Dakota

1 Answer

Parking light nightmare1987 dodge dakota


Your problem could be Rust in rear lights causing bad earth or shorting in parking lights or rear lights as plug shorting so.....unplug rear lights from plug to rear lights inc No plate light, switch on if still blows unplug both parking lights ....then OK so problem in f/p/lights,,connect up Left hand side ,,,still ok then problem in R/H/Parking light ,,,but dont forget when finnished to put them all back, and numberplate light as well (they are the most troublesome light)
Have a goodday

Sep 24, 2009 | 1987 Dodge Dakota

1 Answer

1992 Dodge Dakota LH tailight problem


Have you taken bulb out & cleaned terminals inside socket & either cleaned bulb base & terminals, or tried replacing bulb?

Mar 10, 2009 | 1992 Dodge Dakota

1 Answer

Dodge dakota parking light removale


on the front you need to remove the light housing
on the rear you need to remove the tale light.
RD

Jan 07, 2009 | 2001 Dodge Dakota

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...