Question about 1990 Plymouth Sundance

1 Answer

Fan control relay

I'm trying to locate the fan control relay for my daughter's car. 1990 plymouth sundance. The fan isn't working, and I thought I might check the relay first.
Thanks in advance.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Plymouth Master
  • 6,674 Answers

Quite often you'll find resistor on firewall, of passenger side under hood. 1-1/2"x3" block attached to firewall. In area of where heater hoses enter.

Posted on Mar 12, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fan Relay 1994 Plymouth Sundance


Hi Eric:
Blower Motor is usually only in one of two different locations... the first is on passenger side, access under the hood or, second choice, under dash access behind glovebox.

In both cases the resitor will be in the duct that the blower motor blows through.

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Dec 14, 2011 | 1994 Plymouth Sundance

1 Answer

I cant get spark on my 1990 plymouth sundance. I tried replacing the ignition coil, i put a new pick up point and cap too. any thoughts?


Please make sure that the trigger required for the coil to give out the High voltage to spark comes from the pulsating voltage at the coil LT( low tension).
So check for the make /break on the coil- on one side you will need the positive and on the other the trigger. Once this is seen then the distribution can be checked, check the HT wires and contacts in the distributor.

Jun 21, 2011 | 1990 Plymouth Sundance

1 Answer

My check engine light flashes 35 times on a 92 plmouth sundance i was wondering if u would tell me what thats for


That should be radiator fan relay, open or shorted. If your radiator fan is working as it should, the code may have been stored before rad fan was fixed.

Jun 01, 2011 | 1992 Plymouth Sundance

1 Answer

Iam looking for the location of the blower motor resistor in a 1990 plymouth sundance. Do you know where it is located?


To access the blower resistor,carefully pull down the lower right under-dash panel.(Below the glove box) it it will be right next to the blower motor in the heater housing. it has a plastic connector with a few wires running to is, and 2 bolts holding it in the housing. I hope this helps


Dec 05, 2010 | 1990 Plymouth Sundance

1 Answer

Where is the relay located for the turn signals on an 89 plymouth sundance? The lights work on the signals, but don't blink when you turn them on


your fuse block is located behind the steering column cover acessible by removing the fuse access panel above the hood latch release lever.the relay and flasher module is located behind an access panel in the glove box.included in the module are hazard and turn signal flashers along with time delay and horn relays.you have additional relays mounted on the inner fender panel near the battery and strut tower.

Dec 13, 2009 | 1994 Plymouth Sundance

1 Answer

Blower fan does not work. It has power going in


try changing the coolant sensor, check wiring to fans good, and also the fan relay.

Oct 08, 2009 | 1994 Plymouth Sundance

1 Answer

Replacing the heater core on a '88 Plymouth Sundance?


Behind the dash. You will have to pull the whole dash assembly. It looks like a little radiator.

Mar 28, 2009 | 1988 Plymouth Sundance

2 Answers

Fusebox location


fuse boxes are usually under the dash on the driverside up by the brake pedal and another one under the hood driverside if the fuses are good it may just be you have to replace the fan because there is a relay in the fan that may have went out and check out a salvage yard for a good used one

Jan 25, 2009 | 1991 Plymouth Sundance

Not finding what you are looking for?
1990 Plymouth Sundance Logo

Related Topics:

224 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

63990 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...