Question about 2001 Lexus RX 300

Open Question

No souns radio works lexus rx300 2001

No sound on the speakers radio works lexus rx300 2001

Posted by on

6 Suggested Answers

  • 1 Answer

SOURCE: no sound in car. fuse and radio working perfectly. is there a code??

I had this same issue. My radio had a very soft sound when it was turned up all the way. I found that it was the tmute setup used for hands free phone option. (I did not have this option). I found a wiring diagram and cut the tmut wire on the amp, to my surprise it work. the amp was the only component I could get to. this work for me, I hope it helps.

Posted on May 03, 2009

Molson02536
  • 3854 Answers

SOURCE: code p1130. where is the sensor located

P1130 Air/Fuel Ratio Sensor Circuit Range/Performance Malfunction (Bank 1 Sensor 1) 
This sensor is the hardest to get at. It is between the cat and the cylinder block on the bank of cylinders closest to the firewall. Not much wiggle room back there.
Sensor will run you about $225 from Toyota, $275 from Lexus, but you may be able to get a Denso sensor on line.

Good luck and hope this helps. keep me posted. 

Posted on Jun 26, 2009

keithheavili
  • 410 Answers

SOURCE: ? to Replace Timing belt on 2000 Lexus Rx300 with 57,000 miles.

If it is running perfectly I wouldn't think that you would need to replace the timing belt. You shouldn't need to replace that until 100,000-120,000 miles. I would definitely hold off until now unless you have start having some timing problems. Let me know if you have any other questions. Thanks for rating my response and for using FixYa!

Posted on Jul 08, 2009

  • 17 Answers

SOURCE: replace side marker light on lexus rx300

Remove 3 - 4 screws on fender cover close to side marker light. Pull fender cover out a bit for you to use your other hand to reach side marker light. By twisting on one direction and here you go the light out. Replace new bulb and replace everything on reverse order.

Posted on Aug 18, 2009

  • 185 Answers

SOURCE: Removing the Radio for Lexus Rx300

take the woodgrain cover off around shifter, it pops off. next pull out the small panel just below the radio, pull it straight out towards you, set it aside. there are 4 bolts holding the radio in, you will need a light to see the back 2. remove these bolts and carefully pull radio straight out.

Posted on Oct 03, 2009

jimmybrown67
  • 835 Answers

SOURCE: lexus rx300,2001, how to change knock sensor#2?

some are on the cylinder head or on the side of block . they screw in .

Posted on Dec 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 lexus is250 radio turns on pop in speaker and then no sound


have blown speaker some one turn it up to high and blew it replace it and what the volumne

Apr 19, 2016 | Lexus IS 250 Cars & Trucks

1 Answer

My Lexus ES350 isn't making any sound out of the speakers, but the radio/CD player is on. My Bluetooth hands free phone devise is also picking up calls, but no sound.


Take it to a stereo shop and consider rolling the repair into an upgrade to new speakers. They will test and if the radio / wires are bad just buy a new radio, etc.

Jul 29, 2014 | 2007 Lexus ES 350

1 Answer

Lexus radio sound crackles then cuts out altogether


in radio mode, A./m and F/m
and what about other modes. Cassette, CDDA disc? all crackle
if only radio, then connect a test antenna to the radio
solved?>
if not the radio is bad, or DC power to the radio is bad.

cuts out, does that mean, just the sound dies in all modes. (left and right speakers)
or the sound and even the dial lights and station tune data is dead too.

cuts means nothing with out specifics.

Jun 14, 2014 | 1994 Lexus LS 400

2 Answers

2005 SC 430 Lexus--audio system goes off for no rhyme or reason.


somewhere you have a short in your wires that triggers the fuse in your radio

Nov 21, 2011 | 2002 Lexus SC 430

1 Answer

Lexus rx300,2001, how to change knock sensor#2? where is knock sensor#2?


some are on the cylinder head or on the side of block . they screw in .

Dec 13, 2010 | 2001 Lexus RX 300

2 Answers

I put in a cd player everythings connected but there is no sound coming out of the speakers


check your wiring, make sure its not grounded behind the dash somewhere

Sep 18, 2010 | 1993 Lexus Es 300

1 Answer

Radio works but no sounds lexus es 300


this is a burnt out amplifier problem, the amplifier can be repaired by an authorized Lexus repair shop.

May 05, 2009 | 1996 Lexus ES 300

1 Answer

No sound in car. fuse and radio working perfectly. is there a code??


I had this same issue. My radio had a very soft sound when it was turned up all the way. I found that it was the tmute setup used for hands free phone option. (I did not have this option). I found a wiring diagram and cut the tmut wire on the amp, to my surprise it work. the amp was the only component I could get to. this work for me, I hope it helps.

Apr 14, 2009 | 2000 Lexus RX 300

Not finding what you are looking for?
2001 Lexus RX 300 Logo

Related Topics:

271 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...