Question about 1995 Volkswagen Jetta

1 Answer

Wont run i hav a vr6 that iv just built.. it starts but runs for 5secs and cuts out. all the ecu wiring is correct.. it does have a transponer key.. and u cant get into the ecu with the diagnostic computer, wont let it in.. will the car start if the clusters are faulty.. thanks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Volkswagen Master
  • 14,036 Answers

If you have transponer key . it have to be reprogramm .a regular scanner .will not let you in . dealership job . your car ignition switch in the steering column. i dont think cluster is faulty.

Posted on Mar 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Polo 2001 1.9 ssdi wont start fuelfilter/belt/fuelpump all done ecu was wet dried out wont start


Have you run basic tests? Spark at plugs? Correct fuel pressure at key on? Compression?

Mar 27, 2016 | Cars & Trucks

1 Answer

My seat Ibiza s 1.4 cut out in the wet ain't started since iv been told there is no compression wen I'm turning the key its like it ain't catching


vehicles need three things to run. Spark / Fuel / and Compression. If it's true that there is no compression, the engine will not start. Run a compression test and verify there is compression. This is always the first thing you should do when diagnosing why an engine wont start.Good luck and most of all have fun and don't give up

Nov 02, 2015 | Seat Cars & Trucks

2 Answers

Grand vitara wont start


Do you mean it will not start or the engine doesn't spin over with the starter?

Aug 14, 2013 | Cars & Trucks

1 Answer

Car wont start


something with ignition is failing--or maybe a wire gettn hott--a code like that is combustion related--hav a data stream run to give u values of engine performance--an independent shop or mobilemech has the equipment

Jun 15, 2013 | Cars & Trucks

1 Answer

I hav a 94 chevy k1500 but it wont stay running. One morning i started it up, got it warm then while i was goin down the road it acted like it was running out of gas,would die then start back up then just...


Turn on the key and listen by the fuel tank for the fuel pump to hum. A common problem is low fuel pressure. It will build pressure when the key is turned, use that fuel, and then the pressure drops. Kind of like when you're using a squirt gun that's getting empty.

Feb 28, 2010 | 1994 Chevrolet K1500

1 Answer

I hav the keys from the old car and the speedometer do i still have to take it to the dealer to get pass the security problm i replaced the chips in the keys but my stereo says locked the motor turns but...


It is possible IF you have the ORIGINAL keys to the car to read the resistance of the original key, use Radio Shack resistors and build an IN-LINE resistor to replace the key's requirement to have the chip. After you know the correct resistance for your car, purchase enough resistors to wire in-line to create the right resistance, then in the steering column you will find two micro-sized wires, usually yellow (DO NOT CUT the slightly heavier Air Bag yellow wires). Cut the two yellow micro-sized wires wire your homemade resistor in line between them, tape all of your wiring up good and try to start it... As far as the dash goes, yes you should still have to go to a dealer to reprogram the computer..., You might just consider takng it in anyhow and doing it right.

Feb 24, 2010 | 1999 Cadillac DeVille

1 Answer

1995 Golf gti cuts out, wont start after. Runs fine one day, another cuts out constantly. Not ECU relay or fuel pump relay


Could be the ignition coil. Get a spray bottle and put some soapy water in it and spray the wires 7 coil while the engine is running. You will find your problem.

Jan 13, 2010 | 1996 Volkswagen Jetta

1 Answer

1995 VR6 Golf has starting problems. Seems like Immobilser.


I Have just checked auto data, yes the bent copy lol! system malfunction, engine will run for 1 second and cut out, immobiliser can only be reprogrammed using suitable diagnostic equip. dont mess about get it into a dealer.... or buy a free running ecu..where the eprom chip for the key reading process is cleared..

Mar 30, 2009 | 1995 Volkswagen Golf

1 Answer

Hi please help i have a peugeot 406 hdi i have had nothing but problems with the fuel system first i changed the bosch pump in the tank i then changed the high pressure pump and the car run lovely for one...


Try this but the fault I have is intermittent so may take a bit to work out - switch off everything in the car so there is no noise. Turn on ingnition (do not start) and listen for the sound of of the fuel pump below the rear seat - behind the drivers seat. The pump should run for about 5 - 10 sec then shut off, it may work but if you cannot hear it it may be an ECU issue. If it does run start the car and drive it until it stops again, switch the ignition on/off and listen for the pump running. if you can confirm that the pump is running intermittently you have the same ECU problem I have. The official solution is to replace the ECU - ££££££. The low cost alternate is to run a wire from the ingnition controlled feed at rear of the radio and connect to the pump feed at the fuel tank, ensure a correct rated fuse is installed somewhere along the wire. There is a least one issue with this - if the ignition is on the pump is running, so not a good idea to sit with the key turned to listen to the radio.

Feb 19, 2009 | 2005 Peugeot 405

Not finding what you are looking for?
1995 Volkswagen Jetta Logo

Related Topics:

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

yadayada
yadayada

Level 3 Expert

60667 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...