Question about 1994 Isuzu Trooper

1 Answer

I need help locating the TCM in my 2001 trooper 4X4

I have searched all over the trooper trying to find this TCM and I have not seen anything yet? Can you help me??

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

On the 1994 Isuzu, The TCM is located on the drivers side under the dash up next to the kick panel. Atleast that is where mine is.

Posted on Nov 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I need a tail light wiring diagram for 2001 Isuzu trooper


very old post..



the relay is on the front park page.
fuse F12 is labeled tail light. as is that relay


25127732-3bbyw5su1panbwc4difbb2hq-1-0.jpg

Sep 23, 2014 | 2001 Isuzu Trooper

1 Answer

TCM not working trans is in satety mode have to shift manualley


the TCM , just like the ECU has flash codes

you insert a diag, jumper wire to the DLC and red the fash

codes, say code XXXX tail speed sensor dead.

the 4L30E trans? same as trooper and that fact can help find info.



this is true for all TCM made , all

on new cars uSA 1996 + the PCM reports, TCM errors.

why not login in to alldata.com and see these simple steps.

why guess? for $15 bucks, amazes me....???



94 Rodeo

finding old rodeo TCM facts is like pulling teeth, (very few run now)



DLC conn

jump pins 1 and 3 for TCM

this is trooper hope is same

http://www.2carpros.com/forum/automotive_pictures/248015_Picture1_11.jpg



3 pin DLC conn

1 and 2 is ECU flahs

1 and 3 is TCM. 1 is ground.

jumper it.

see lamp flash the code.

the 2 pin connector is for the Tech1 scan tool no one has now.



had to find.

code: (keep in mind many codes see LIMP mode, skips gears.)

16 is oil temp failure.



google works with 4L30E, and isuzu.

http://www.motor-talk.de/forum/aktion/Attachment.html?attachmentId=699188

see that.

see page 237 , it even shows the trooper connectors.

and the flash codes.

but you must figure out type 1 or 2.

only

ah it say type 2 is yours.

so now you have a full DTC error map for your car.

and all it cost is a paper clip

Aug 02, 2014 | 1994 Isuzu Rodeo

1 Answer

2001 isuzu trooper what is the e-diode in the fuse box and do you need it,the engine runs but knocks, just got back from iraq so just now getting to look at it myself, was looking at fuse bos and seen the...


The diodes are there to prevent a current back-feed, yes they need to be there. The knocking may be a fuel seperation problem [ ethanol seperation ] from setting. Useing a fuel stabilizer when storring a vehicle for long period of time will prevent it.
Hope this helps you.

Feb 18, 2011 | 2001 Isuzu Trooper

1 Answer

Can a 99 isuzu trooper tranny work in a 2001


search around for auto recyclers via a google search. find one with a searchable inventory, they are out there. marshall's in circleville, ohio is one. search for a transmission for a 99 isuzu trooper and for a 01 trooper transmission. if they have the same interchange part number, you are good to go. if not, you will find certainly one that is.

Feb 08, 2011 | 2001 Isuzu Trooper

2 Answers

4l30e transmission solenoid replacing 1-2


pull the trnasmission pan off, the solenoids are attached to the vlave body inside the trans.

Sep 19, 2009 | 2001 Isuzu Trooper

2 Answers

No reverse 2001 ram 1500 4x4 5.9


sounds like just bad luck
Its like the reverse band needs adjusting so make sure tranny fluid is clean no bunt smell
if its discolored or smells burnt then its clutches & bands!

Jul 18, 2009 | 1998 Dodge Ram 1500 4WD

2 Answers

4x4 light is flashing (TOD indicator)


this means there is a problem if it continuosly flashes
Short-circuit terminal 8 of the self-diagnostic
connector to GND to display the trouble code on the
CHECK lamp.
If no trouble codes exist, code “12” is displayed continuously.
If trouble codes exist, code “12” is displayed three times, and then other trouble codes, starting from the smaller code number, these are displayed three times respectively.

this is located behind right front centre console side trim..
2eb44e9.jpg

Jun 30, 2009 | 2001 Isuzu Trooper

1 Answer

I cannot located the TCM on my 2001 isuzu trooper


under pessinger seat you will find it!!!

Mar 09, 2009 | 2001 Isuzu Trooper

1 Answer

Replacing oil pump on 92 4x4 isuzu trooper


undo engine mounts jack engine up as far as it will go

Nov 19, 2008 | 1992 Isuzu Trooper

2 Answers

2001 Trooper: Front axle will not engage when I press dash 4x4 switch


hi guys i would check all the small vacume pipes that conect the sol valves toi the vacume actuators having just replaced the engen in mine i found that these do not have any clips holiding them on tight and can get oil on them and become oversized and leak you can test the diaframes in the actuators by putting a length of pipe on one port and sucking by mouth you can hear the actuator move and then find you can put toung on end of pipe and it will hold a vacume if it does not then chances are the actuator diafram id u/s hope this helps bill

Nov 09, 2008 | 2001 Isuzu Trooper

Not finding what you are looking for?
1994 Isuzu Trooper Logo

Related Topics:

296 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...