Vivaro with no ignition lights battery reads 12 v all engine fuse
Ok parked the van on friday night came to it monday morn the door does int open with remote i opened drivers door with key no ignition lights called AA they come out check all fuses all engine fuses ok 12volts in battery but cant check fuse box at passenger side because dead locks are on and cant open door anyone know of a problem or if it is a fuse and how do you remove dead locks with no power in van
An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: vivaro with no ignition lights battery reads 12 v all...
Did AAA jump your battery? if not hook a comercial battery charger up to; or, remove recharge; your battery: this should release the locks then: you have either short draining your battery or, a bad alternator or, battery
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Rear fuse box. INT LP 10 amp . there is also INT LP relay in the same rear fuse box .
Fuse Block - Rear
Under the rear seat, on the left side of the floor pan
The INT LP fuse in the fuse block - rear supplies battery positive voltage to the normally open switch contacts of the INT LP relay. The INT LP fuse also supplies battery positive voltage to the INT LP relay control circuit. The fuse block - rear also supplies battery positive voltage to the relay control circuit for the front courtesy lamp. The door modules communicate on a simple bus interface (SBI). When you open any door, the switch contacts of the door open switch close. When a door open signal circuit is grounded, that door module sends a message to the drivers door module (DDM) in order to indicate that a door is open. The DDM sends a class 2 message to the rear integration module (RIM) in order to indicate which door is open. The RIM activates the INT LP relay in order to provide battery positive voltage to the interior courtesy lamps. When any front door is opened, the RIM will energize the FRT CTSY lamp relay grounding the I/Pcourtsey lamps at G302. Depending on which doors are opened, front or rear, the proper interior courtesy lamps illuminate. The RIM provides a pulse width modulated ground to all interior courtesy lamps for the interior lights theater dimming feature. Some of the courtesy lamps are also used as reading lamps, each reading lamp may be manually turned on or off using it's own respective switch
I would recommend going to a dealership. Though more expensive, they are far more reputable than some guy that like chicken wing & pizza on his 9th 15 min break haha. Dealerships always go about the right diagnosis and approach to each issue, 1) the Car 2) the customer 3) everyone being happy in the end. Good Luck :)