Take out altinater on 1999 town and country
Fi disconnect battery then loosen pulley tensioner to get belt off then you should unbolt alt
SOURCE: 1999 chrysler town and country--no a/c
bypass the relay and test it you can take 2 wiles black coming off of it is the negative or ground wire if it dosnt work on direct power it compressor is bad and you need a new one
SOURCE: how to replace our low beam headlight on 1999 town and country
1.) Open the hood of your van
2.) On the passenger side of the vehicle, look behind the headlight
enclosure. You will see a set of wires running into the back of it.
This is the power clip. Either with your hand or a flat-head
screwdriver, pop the power clip off.
3.) There is a plastic ring encasing the light bulb. Turn the
ring counter-clockwise and pull it out of the socket and set it aside.
4.) Pull firmly on the light bulb to remove it.
5.) Place the new light bulb into the same opening. Be careful
not to touch the glass part of the new bulb. The oils in your skin can
substantially reduce the life of the new bulb.
6.) Replace the plastic ring and turn it clockwise to lock it in place.
7.) Reattach the power clip to the back of the bulb.
SOURCE: Front PCV Valve on chrysler town and country
PCV valve location-2.4L engine
PCV valve location-3.3L and 3.8L engines
SOURCE: The alarm on my 1999 Town and Country won't go off, what do I do?
Disconnect the battery for about two min that should work.
40 views
Usually answered in minutes!
×