Question about 1995 Nissan Pickup

1 Answer

Can you replace the bearing on the A/C clutch on a 1995 Nissian Pickup, 2.4. Auto.

Posted by on

  • jphinton49 Mar 10, 2009

    I still need to know how to replace it.



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 87 Answers

You can but it is better to get a complete clutch or a rebuilt unit

Posted on Mar 09, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Find a heater motorfan bearing for 1995 sl0 pickup

Replace the whole motor, seperate parts for the motor are not available.

Mar 04, 2015 | Chevrolet S 10 Cars & Trucks

1 Answer

How do I remove starter from a 1995 nissian pickup truck ?

Model and engine size please?

Master Tech Lee

Dec 08, 2014 | Cars & Trucks

1 Answer


Go to a auto parts store (Pep Boys, Auto Zone, Advance, O'Reilly's, etc. ...they all have vehicle specific manuals for sale that will have a section on torque values.

Dec 26, 2010 | 1995 Toyota Pickup

1 Answer

I have a 1994 Nissan pickup. v6 manual trans. I get a loud hum as I drive. But when I press the clutch in, the hum stops. release clutch and hum starts. Could this be the Clutch fan?

No, By pushing in the clutch to stop the hum all you are stopping from turning is the transmission and ( transfur case if 4 wheel drive ) the engine is still running ..and some parts in the rear differential . I have had 4 nissan pickups and currently drive a 1995 pickup, without actually hearing the noise I would look toward the transmission, these Manual transmissions are very prone to bearing failure. This has happened to 2 of the one's I have had including the one I have now. You can also see as time goes by if the noise is quieter in fourth gear than others because this is direct drive and not as many trans bearings are involved Good Luck

Oct 22, 2010 | 1994 Nissan Pickup

3 Answers

Why do I sometimes have a hard time putting it in gear its a manual

Hi the chances are the clutch will need replacing if this has not been done before then this is something that will need doing, you need to get the clutch,pressure plate and thrust bearing replaced this all comes in a clutch kit, getting this done will solve your problem

Aug 18, 2010 | 1995 Nissan Pickup

1 Answer

Clutch replaced and slave replaced and master 95' nissian maxima

If you're sure that the system has been bled properly, then you probably have a problem inside the transmission. Could be a broken clutch fork or blown release bearing. Make sure you've checked the hydraulics first though, sometimes it is difficult to get all the air out and you may need to use a pressure bleeder. Most brake shops have these.

Mar 03, 2010 | 2004 Nissan Maxima

2 Answers

Clutch slips in high gear when I give gas going up hills in 94 nissan pickup. can I ajust it? thanks

might able to adjust it, but it wouldnt be worth it
if it slips when alot of resistance is put the the vehicle, it requires a new clutch for sure.

Jun 16, 2009 | 1994 Nissan Pickup

1 Answer

I need to replace the bearing on the air conditioner compressor.The bearing on the pulley.

You will need to replace the clutch assembly on the compressor. This is not an easy job for a novice but if you have some experience you should be able to do it. You may be able to rent the puller and the installer form your local auto parts store where you but the clutch.

Jun 11, 2009 | 1995 Buick LeSabre

1 Answer

Rattle during acceleration

it sounds like it could be a lower rod bearing going out

Feb 18, 2009 | 1995 Nissan Pickup

1 Answer

1990 nissian pickup air conditioner

Only a mechanic can fix the a/c because mine had similar problems

Jun 22, 2008 | 1991 Nissan Pickup

Not finding what you are looking for?
1995 Nissan Pickup Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

77499 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides