Now it wont start and gas gage says im emty but it has a full tank\
Check fuses first, then I would check the wiring harness for any issues.I would say fuel issue definitely. Sometimes the pump and gauge are one unit, sometimes separate, but they share the same wiring harness.
SOURCE: f350 no start
I have a feeling you got a wholed of unleaded fuel or bad fuel
I drive a diesel box truck the station I always took it to the fuelman put unleaded in the diesal tanks and the truck just died it had to have the gas tank completed drained and cleaned out but also ask yourself how many miles are on it and when was last tune up and if you live in a cold climate I recommend a heater block plug
SOURCE: Shut 05 Ford f350 diesel off wont start
when you get a code the PCM will keep that code and till it get easased. you need a scaner or disconect your battery for 1h. this should clear your codes. when the battery is disconected don't sit in your can. the air bags may deploy if you hit the steering collem or a sensor to hard. just let it sit. reatach your battery then try to start your truck. if the codes are still pressent you make need let the car sit for longer or bit the big one and get the shop to do it.
SOURCE: Shut 05 Ford f350 diesel off wont start
dies the truck restart once it cools off? it is very common for th 6.0 to have high pressure oil issues on a hot soak. they will run till the cows come home but once shut off they can not build up enough pressure by cranking speed alone to start truck until it cools down and the seals become rigid enough to bridge the gaps they are sealing in the first please. if this is the case. it may be the STC fitting ojn the back of the high pressure oil pump (intake and turbos must be removed to check) or possibly the branch tube o rings have worn. the branch tubes are located under the valve covers and supply the fuel injectors the oil they need to perform their "power stroke"...
SOURCE: 1999 f350 diesel engine shut down, turns over but
that fuse powers pcm fuel heater and some other things. when the fuse blows the pcm shuts down. causing it to not run. usually its the heater that is bad. it is located at the back driver side by the fuel pump. you can unplug it and see if it starts. if so you will need to replace the heater
91 views
Usually answered in minutes!
×