Question about 1999 Daewoo Lanos

1 Answer

Where is the location of the possitive crankcase ventilator

Can you please tell me where I can find the positive crankcase ventilator of daewoo lanos hatch 1999 with a15sms engine.

Posted by on

  • emerlito Mar 13, 2009

    sir, they are asking for payment for just telling me where i can find the pcv valve.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 527 Answers

Sir,
Just go through the Link. If you have not get ur answers, better to post a question on that site.


Thanks Good Luck
Appreciate to rate as "Fixya"

Posted on Mar 10, 2009

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Please show me a picture that shows the position of oxygen sensor on a daewoo lanos 1999 model 1.6 litre


Oxygen Sensor

1999 Daewoo Lanos 1.6L MFI DOHC 4cyl

The Oxygen Sensor is located: Under hood, driver side, lower engine area, above exhaust pipe flange, mounted in exhaust manifold,don't have a picture.Here's a link to what it look's like just remove the electrical connector,get a open end wrench and remove.. http://www.autozone.com/engine-management/oxygen-sensor/bosch-oxygen-sensor/daewoo/lanos/1999/4-cylinders-6-1-6l-mfi-dohc/4971_102074_1784_97999

May 25, 2015 | 1999 Daewoo Lanos

1 Answer

Whats a cam shaft position sensor and where loacted on 2000 daewoo leganza


The Cam Shaft position sensors job is to send a signal to the coil to tell it to fire the spark plugs, it will be located under the timing belt cover.

May 25, 2014 | 2002 Daewoo Lanos

1 Answer

How do you get the pcv valve out of the valve cover


Usually you grasp it an pull it out.

Positive Crankcase Ventilation (PCV) Valve Removal & Installation To Remove:
PCV Valve location (3.3L & 3.8L engines shown, 2.4L similar) chry-04-33-829.gif

  1. Disconnect the vacuum hose from the positive crankcase ventilation (PVC) valve.
  2. Remove the positive crankcase ventilation valve from the valve cover.
To Install:
  1. Install the positive crankcase ventilation valve in the valve cover.
  2. Connect the vacuum hose to the positive crankcase ventilation valve.
prev.gif next.gif

Jan 16, 2011 | 2006 Dodge Grand Caravan

1 Answer

CAMSHAFT


on single cam engine its inlet manifold side just behind cam gear rear cover bolted into cam box cover
twin cam its behind cams in middle front of engine in centre of rocker cover remove cover over h.t.leads this one is eazy but tricky due to bolt inside cam belt cover

Jun 28, 2009 | 1999 Daewoo Lanos

1 Answer

Location fo pcv valve on 2001 ford ranger 4 cyclinder 2.3


I think it is in the valve cover. see illustrations from shop manual.



Positive Crankcase Ventilation System Overview The Positive Crankcase Ventilation (PCV) System (Figure 132)cycles crankcase gases back through the engine where they are burned. The PCV valve regulates the amount of ventilating air and blow-by gas to the intake manifold and prevents backfire from traveling into the crankcase. The PCV valve should be mounted in a vertical position. On some applications, the PCV system is connected to the evaporative emission system (refer to the VECI decal). located on the underside of the hood or on the radiator cooling fan shroud.

crankcase ventilation tube
d176823.gif
  1. Remove the positive crankcase vent (PCV) hose from the clips.
cc83fb4.gif

Apr 17, 2009 | 2001 Ford Ranger Regular Cab

1 Answer

Location of the Throttle Position Sensor on a 1999 Saewoo Lanos ?


Sir,
Check this link. It applicable to all models.
Thanks Good Luck
Appreciate to rate as "Fixya"

Mar 10, 2009 | 1999 Daewoo Lanos

1 Answer

Locating camshaft positioning sensor on 2000 Daewoo Laganza


when you open your hood and you look on the valve cover you see on your left side of top of your cover a cable sticking out from a black piece that is the positioning sensor that cranksup the car

Mar 03, 2009 | 2000 Daewoo Lanos

2 Answers

Motor oil spitting out from the dipstick. No smoke, no blow by.


Have you checked for a PCV valve plugged? Not sure if there is one an that, but would sure look for one. Crankcase ventilation somewhere.

Feb 25, 2009 | 1999 Daewoo Lanos

Not finding what you are looking for?
1999 Daewoo Lanos Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

61037 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...