Question about 2004 Mitsubishi Endeavor

1 Answer

My a/c blower has quit blowing. I have removed the blower motor and checked it out and it works. Could this be a relay issue?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 400 Answers

Yes more than likely your ac relay may be bad, but it can also be the fan speed selector.

Posted on Mar 09, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

How do I change heater fan

It would help to know the make and model. Different manufacturers put them in different places and mount them different.

Feb 19, 2015 | Cars & Trucks

1 Answer

Fan motor not working on 2006 Jeep Grand Cherokee.

I had this same thing happen to me in a Buick Lesabre. It ended up being the blower relay. There was 2 relays for the blower motor. One was called the high blower relay which controlled the high speed. The one that fixed the problem was the blower relay that powered up all the other speeds. I hope this helps.

Oct 13, 2014 | 2006 Jeep Grand Cherokee

3 Answers

1998 S10 ABS light on, blower motor and wiper motor quit working

Sounds like your computer got wet. Could also be a bad battery, make sure you do a load test and check it. Any auto parts store will check it for free.

Jul 16, 2013 | 1998 Chevrolet Blazer

3 Answers

The a/c on my 2010 Mercury Milan quits blowing after about 2 hours of driving. Any ideas?

Sounds to me like the A/C clutch is no good and out of adjustment.You should goto your nerrest junkyard and get a used assembly take the clutch off then you learn how it comes off and install it on yours the save the pump for later use if needed. The clutch should only have a .010 air gap after install between th inner elctro magnet and the clutch plate it's self.

Aug 04, 2012 | 2010 Mercury Milan

1 Answer

We have a 1997 oldsmobile cutlas ciera. The heat is working but barely blows and sometimes doesn't blow at all. We think it's the blower motor and want to order the part but need to make sure this is the...

This could quite possibly be the issue but prior to purchasing a blower motor check the plug that runs to the blower motor for a burnt or frayed wire.usually when it works intermitenttently like this the wiring is an issue.If the speeds are not functioning correctly the blower resistor is having issues check the plug to the resistor as well.

Dec 14, 2010 | 1997 Oldsmobile Cutlass Supreme

1 Answer

Heater does not blow warm or cold can feel the air but does not blow

Had a similar problem with my friends 2002 Silverado, first the blower motor started making funny noises and then quit working. Cost $45 to replace.

Before getting a replacement, check fuses and relays related to that circuit and make sure there is power going into the blower motor.

Good Luck

Mar 03, 2010 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Heater has suddenly quit working i can hear the compressor kicking in it is just not blowing


Jan 25, 2010 | 2000 Pontiac Grand Prix

1 Answer

My A/c quite blowing at all. I am assuming it is

The GM trucks do not use vacuum to operate the HVAC system. Check for power at the purple wire at the blower motor. If you have power and the blower motor is still inop, replace the blower motor. If you have no power, check the relays and resistor behind the glove box. Four screws hold the glove box in place.

Jul 09, 2009 | 1998 GMC Sierra

Not finding what you are looking for?
2004 Mitsubishi Endeavor Logo

Related Topics:

466 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides