SOURCE: Exterior rear door handle on Honda Accord 2001
To Remove Door Panel on 2001 Honda Accord:
A: To remove the plastic piece with the door lock button and door handle connected to it:
1- Remove the screw in the middle located behind a plastic cover button
2- Push (slide) the whole assembly Forward (toward front of car)
Besides the screw, it is held in place by 3 hooks on the backside that hook into holes in the metal door frame
3- Now unhook handle from small metal bar going through door by pushing (toward door) plastic clip (blue?) off of the bar, then the bar will come out of the clip hole, thus releasing the handle.
4- Depress little grey button /bar (purple painted on it)on elec. connector to seperate connector, thus releasing door lock switch
Now the whole assembly (metal handle, door lock switch, and plastic piece) will come off door panel
B: The door is held on by 2-screws, 7-plastic snaps/plugs, and 1-plastic plug.
The screws are located: bottom of hand hold and the other behind the handle, both covered by little covers that have to be pryed off to access the screws.(hint: the screw with the built in spacer goes behind the handle when you are trying to reinstall)
The 7-plastic snaps: 3 across bottom and 2 on each side. Not visible, they are mounted to the inside of the panel.
The 1-plastic plug is visible at the upper front of the panel and is the same color as the surrounding trim
C: Take off the big plastic triangle piece above the door panel and behind the mirror. Pull/pry off. It has 2 snaps holding it on. one near bottom and one near the front.
D: Light lens prys off from bottom. Unscrew (1/4 turn) the light assembly with bulb still intact from backside of panel
E: Remove the Hand-Hold/window switch assembly:
SOURCE: '92 Honda Accord driver's side door won't open from interior
1. This may require removal of the interior door panel which should not be too difficult to figure out where all of the screws are.
2. Take your time and don't get too wild when forcing or pulling anything. If it fails to come off there is probably yet another clip or screw you missed. Many of the screws are hidden under little caps.
3. I would find a wrecking yard near you that has the part and know ahead of time if you must pull the donor part or if they pull it for you.
SOURCE: Door panel removal from 2005 Honda Accord
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: take apart honda accord drivers side door
inside the handle there is ONE screw covered by a piece of plastic. remove the plastic and then remove the screw. pull handle out and disconnect it from the door latch bar. replace in reverse
SOURCE: 2008 honda accord replace rear brakes
no, 12mm wrench or ratchet on 12mm socket. the piston is tough to push back in. its a twist in type and you will need some force to push and twist the piston back in. - note rear brake pads wearing out on the new 08-09 accords are very common and if under 16-18 thousand miles it may be covered. honda knows about this problem
3,671 views
Usually answered in minutes!
×