Question about 1998 Pontiac Grand Prix

1 Answer

I am replacing intake gasket on my 98 pontiac grand prix supercharged gtp and need to know the torque setting for intake bolts

Posted by on

  • Anonymous Mar 16, 2014

    torque settings for 2000 grand am gt rocker bolts

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 337 Answers

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What are the intake manifold torque specs on a 2005 Pontiac grand Prix gtp 3.4 liter with super charger?


If it were mine, I'd want to be very sure what it was and so I always use a Repair Manual I can see and read, but that me.

Mar 13, 2015 | 2005 Pontiac Grand Prix GTP

2 Answers

How can I replace the water pump on a 2004 Grand Prix GTP superchargered?


WELL YOU NEED TO DRAIN COOLANT SYSTEM.PLACE A LARGE DRAIN PAN UNDER THE RADIATOR TO CATCH COOLANT WHILE DRAINING RADIATOR.ONCE ALL COOLANT DRAINED OUT.REMOVE DRIVE BELT.REMOVE WATER PUMP PULLEY.REMOVE POWER STEERING PUMP AND MOVE IT ASIDE.THEN REMOVE WATER PUMP.MAKE WATER PUMP MOUNTING SURFACE CLEAN THEN INSTALL NEW WATER PUMP AND GASKET IN PLACE.IF WATER PUMP GASKET IS PAPER TYPE PUT GASKET SEALANT ON BOTH SIDES OF THE GASKET.IF YOU HAVE RUBBER GASKET DONT USE NO GASKET SEALANT.INSTALL NEW WATER PUMP TORQUE LONG BOLTS TO 25 FT LBS AND TORQUE SHORT BOLTS TO 16 FT LBS.TORQUE WATER PUMP PULLEY TO 115 INCH POUNDS.TORQUE POWER STEERING PUMP BOLTS TO 25 FT LBS.THEN INSTALL DRIVE BELT.FILL THE COOLANT SYSTEM.START THE VECHICLE AND CHECK FOR LEAKS.

Mar 25, 2011 | Pontiac Grand Prix Cars & Trucks

1 Answer

Can I take a super charger out of a Grand Prix GTP and fit it on my Grand Prix GT 3.8L V6?


Well, the short answer is "yes". But - it isn't nearly as simple as just bolting the supercharger onto the intake and VOILA!, now you're supercharged. The procedure that you're inquiring about is commonly referred to as a "top swap", and there are numerous parts you will need for both engine as well as the transmission. Why the transmission? Because the GT and GTP use different gear ratios and the GTP has a 4T65HD as opposed to the 4T65E that is in the SE/GT. You will also need to have the PCM reprogrammed to accomodate all of these changes.

HERE is a great website that has a ton of very useful information, regarding this and many other Grand Prix topics.

Hope this helps and thanks for using FixYa!

Oct 20, 2009 | 2000 Pontiac Grand Prix

4 Answers

Supercharger oil leak


There is seal kits.available for the.m 90 supercharger on the 3800 go to zzperformance.com youl find an eye.full off aftermarket and hard to find parts for the gtp.

Jul 16, 2009 | 1999 Pontiac Grand Prix

1 Answer

'98 grand prix GTP belt tensioner replacement


I didnt have to remove my alternator, I just used a 15 mm wrench to remove the left-hand threaded bolt holding the tensioner on. hope this helps

Jul 14, 2009 | 1998 Pontiac Grand Prix

1 Answer

Can't seem to locate the pcv on friends 99 gtp supercharged anybody know where it is located?


It is located behind the supercharger rotor housing on the drivers' side, almost straight across from the intake plenum. It is mounted beneath a rhombus shaped plate with 2 1/4" bolts. The valve is mounted on top of a spring and there is a gasket on the bottom of the plate so be careful not to break it...it's not rubber. The plate holding it down also bolts into aluminum so don't over tighten.

Jun 12, 2009 | 1999 Pontiac Grand Prix

1 Answer

Replacing 90 pipe assembly part on 1997 Grand Prix GT


If its the same as my GTP, its just under the Supercharger right in the middle of the intake.
Just pull it out, its only held in with a O-ring. When you replace it, make sure you lube the gasket with grease so its easier to put back in, and less likely to nick the O-ring.

Mar 08, 2009 | 1997 Pontiac Grand Prix

1 Answer

Remove supercharger on pontiac GTP 1999


Technically you are supposed to (change the s/c gasket) but if your careful and don't tear it, you don't really need to.

Be sure to inspect the yellow coolant o-rings.

The gasket thickness isn't going to matter at all on the supercharger gasket.

Perfect oportunity to install that Intercooler you always wanted ;)

Nov 10, 2008 | 2007 Cadillac CTS 3.6L

Not finding what you are looking for?
1998 Pontiac Grand Prix Logo

255 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...