I have a problem with driver's side power window. It will roll down jsut fine, however I cannot get it to roll up. It used to work fine, and recently I would have to push the switch up multiple times before it would go up and now today it will not roll up at all, but it still rolls down without a problem. I took the mechanism out of the door or arm rest and all the wires seem to be connceted properly. PLEASE HELP
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Window motors & regulators go bad every day. Pull your door panel, unplug the motor, if you have an ohm meter apply the leads to the leads into the motor. One will be ground the other two will raise and lower (reverse) the motor. If you show resistance between the leads the motor windings are good and the problem may be the window regulator. If you do not have an ohm meter, you can run two wires (one ground, the other hot) and test the motor by applying elec to it.
First check your fuse panel. Other than that...Perhaps moisture has gotten in the door panel and messed with the connection. I would take the panel off and investigate..make sure everything is plugged in.
well check window switch on driver side first does it roll down from that side / does it roll down from passenger side/ next if not do you hear the motor if yes its the switch in driver door that is bad / if you don here the motor then its the regulator/motor that needs replacing/ Please rate my response thank you very much