Question about 1996 Honda Civic

1 Answer

I need procedure to replace right side half shaft on 1006 Honda C

Step by step procedure to replace right side half shaft

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 337 Answers

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The running bords on my 2008 Yukon stop working


Circuit/System Description
The assist step control module (ASC) controls the running board actuators to extend or retract the running boards. Each actuator consists of an electric motor and a potentiometer. The module supplies a low reference and 10-volt reference source voltage to the potentiometer. The ASC control module monitors the voltage drop across the potentiometer on the position signal circuit. When the actuator shaft rotates, the voltage on the position signal circuit changes. The ASC control module supplies the actuator motor with a 12-volt control circuit and a ground control circuit. The ASC module controls the direction of the actuator by changing the polarity of the control circuits.
You should take this to a ASE certified repair shop that has the diagnostic tools to check for stored DTC'S in the running board control module . A code reader for check engine light codes will not work for this system !
This system can set numerous DTC'S
?€¢
Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors
DTC B051A 0B: Left Side Assist Step Motor Control Circuit Current Above Threshold

DTC B051A 01: Left Side Assist Step Motor Control Circuit Short to Battery

DTC B051A 02: Left Side Assist Step Motor Control Circuit Short to Ground

DTC B051A 04: Left Side Assist Step Motor Control Circuit Open Circuit

DTC B051B 0B: Right Side Assist Step Motor Control Circuit Current Above Threshold

DTC B051B 01: Right Side Assist Step Motor Control Circuit Short to Battery

DTC B051B 02: Right Side Assist Step Motor Control Circuit Short to Ground

DTC B051B 04: Right Side Assist Step Motor Control Circuit Open Circuit

DTC B051C 01: 10 V Reference Circuit Short to Battery

DTC B051C 02: 10 V Reference Circuit Short to Ground

DTC B051C 2A: Left Side Assist Step Position Sensor Circuit Too Many Pulses

DTC B051C 22: Left Side Assist Step Position Sensor Circuit Low Time < Minimum

DTC B051C 29: Left Side Assist Step Position Sensor Circuit Too Few Pulses

DTC B051C 62: Left Side Assist Step Position Sensor Circuit Actuator Stuck Open

DTC B051C 63: Left Side Assist Step Position Sensor Circuit Actuator Stuck Closed

DTC B051D 2A: Right Side Assist Step Position Sensor Circuit Too Many Pulses

DTC B051D 22: Right Side Assist Step Position Sensor Circuit Low Time < Minimum

DTC B051D 29: Right Side Assist Step Position Sensor Circuit Too Few Pulses

DTC B051D 62: Right Side Assist Step Position Sensor Circuit Actuator Stuck Open

DTC B051D 63: Right Side Assist Step Position Sensor Circuit Actuator Stuck Closed
If you don't know how the system works you could make it worst !
You

Aug 16, 2015 | Cars & Trucks

1 Answer

Cv joint replacement


Replace the half shaft its a pain but worth it

May 03, 2013 | 2000 Ford Focus

1 Answer

I need to know how to replace the right front half shaft on a 2004 silverado !


I can send you a complete step by step and diagrams but I have to do it through email. iambanshee74@yahoo.com

Jul 08, 2010 | Cars & Trucks

3 Answers

Average cost for a cv joint on honda accord 1998


there are tow types, with ABS and W/O ABS, they come as a half shaft assmebly, this is a axle and CV joint together. here are the 2 part numbers for left and right axle with CV joint. Price and Part s are from www.rockauto.com, the lowest price on the internet I could find, very fast shipping.

THESE ARE FOR THE RIGHT SIDE AXLE AND CV JOINT ASSEMBLY.
A-1 CARDONE Part # 604153 {[CV Half-Shaft Assembly] Reman.}
Front Right; w/ABS
$42.99

A-1 CARDONE Part # 604152 {[CV Half-Shaft Assembly] Reman.}
Front Right; w/o ABS
$42,99

THESE ARE LEFT SIDE AXLE AND CV JOINT ASSEMBLY.
A-1 CARDONE Part # 604155 {[CV Half-Shaft Assembly] Reman.}
Front Left; w/M.T. w/ABS
$53.79

A-1 CARDONE Part # 604150 {[CV Half-Shaft Assembly] Reman.}
Front Left; w/A.T. w/o ABS
$51.79

Oct 25, 2009 | 1998 Honda Accord

1 Answer

O2 Sensor replacement


On Honda Accord the O2 sensor is located either on the exhaust manifold near to the front or side of the manifold, or in the manifold rear side, depending if it is a four or six cylinders model.

To give an idea of the job, check this website showing the procedure on a different car:

How to Replace an Oxygen Sensor -

To find step by step for your car, I suggest buying the Haynes manual.

To order the part you can use the website below, or buy it at a local car parts shop.

Honda Oxygen Sensor - Oxygen Sensors - Partstrain.com

Feb 21, 2009 | 1986 Honda Accord

1 Answer

1997 rear drums


My suggestion is to go to an auto parts store and buy yourself a copy of the Haynes 1997 F150 half ton pickup manual. Short of that it would be very difficult to explain the step by step procedure. that is why, those of us who have been where you are always do one wheel at a time with the other original wheel our reference.

Good luck davisintexas Loringh

Dec 04, 2008 | 1997 Ford Econoline

1 Answer

94 eagle talen


on the front wheel drive, axle removal is the same for both sides, the drivers side is just longer.
here is a step-by-step guide to removing it.

Oct 24, 2008 | 1995 Eagle Talon

1 Answer

Front axle how to remove half shaft


Hi.. The step to remove the front Axles of you Vitara.
Raise and support Vehicle . Remove front wheel,
Drain Diff,fluid,
Remove Locking Hub if is equipaded,
Remove Circle clip from axle shaft
On right side of Vehicle, Remove the Stabilizer Little ball joint nut. Remove castle nut Front Tie rod end,
Remove mounting bolts from brake calipper,
Remove Calipper from steering knuckle and wire a side.
Remove Stud Nut from steering knuckle,
Support Lower suspension arm with a jack,
Remove lower strut bracket bolt ,
Lower jack and disconnect Knuckle from lower suspension crontrol arm,
Pull Outler joint from Hub.
Use Large screwdriver or Prybar To pry Right inner joint from differential, The axle will go out making a little froce with the prybar,
To remove the left side,
Remove mounting bolt from inner joint flange,
Pull out axle from hub.

To reinstall just reverse the prosses.

I hope this help on your job...
Thank you for use fixya....


Aug 18, 2008 | 1999 Suzuki Vitara

Not finding what you are looking for?
1996 Honda Civic Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...