Question about Chevrolet Caprice Classic

3 Answers

How do I take off and put on a starter to a 1996 chevy caprice classic 350 engine?

Posted by on

  • robbinsk5 Mar 09, 2009

    Thank you for your help, I will do this procedure tomorrow.

×

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 19,396 Answers

You will have to remove the steering wheel, then the lock plate, and the turn signal stick , and then grab the ignition cylinder with a special tool to remove it.
The new cylinder must be keyed and programmed to match your ignition key.
The replacement can also be done at the car dealer for about one hour labour.

Regards

Posted on Mar 09, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,011 Answers

Unhook the battery first negative side . then the starter is located on the passenger side under the motor by the transmission .there are two 15mm. bolts that hold on the starter .loosen these but dont take all the way out if possible ,then there are wires big and little the big one should be a 13mm. size nut the small depending on the year will be 10mm or 11/32 nut size these have to come off .then take big bolts the rest off the way out .then pull out starter.!

Posted on Mar 09, 2009

  • mike loshbough
    mike loshbough Mar 09, 2009

    how in the hell did this guys solution top mine!!!!!!!!!!!!!!

  • mike loshbough
    mike loshbough Mar 09, 2009

    ARE YOU KIDDING NE

×

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 117 Answers

You will have to take out 2-3 bolts from the starter housing depending on the starter. Disconnect the electrical wires to the starter making note where they go perhaps marking them, and then, just reverse the procedure to install. Not to tough to do.

Posted on Mar 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 chevy caprice classic 4.3 v8 I have put new plugs,wires,coil, distributor cap, and all sensors on this car. When its cold it runs like a new one,when it gets hot it wants to skip.What could be wrong?


4.3 enginges have a notorious ploblem with the distributor failing exspecially when engine is warm. If this car has the optical distributor the optics inside fail.

Nov 19, 2010 | 1996 Chevrolet Caprice

2 Answers

Is the 94 caprice classic engin a 350?


probably a 305, check the 8th digit on your VIN #, if it's an R, i think it's a 305, K would mean a 350...hope this helps
also, call chevorlet and they will tell you....also, it could be an LT1

Jul 21, 2010 | 1994 Chevrolet Caprice Classic

1 Answer

Where is the fuel filter located on a 1996 chevy caprice with a 350 engine


under car follow fuel line from fuel tank towards engine mounted on inside frame rail on drivers side will see fuel filter

Jun 23, 2010 | 1996 Chevrolet Caprice

1 Answer

1996 chevy caprice classic engine wont turn over


first,, had the engine stoped before you friend turned up, or did he stop it????
if you took the battery off has the car got a car alarm fitted to it if so, could it be the alarm immobiliser killing the feed to the starter??? also has the car ignishion kye got a chip in it to switch off the alarm? no chip no run like? and last have you put the battery on right and is it a good battery not a dud one

Feb 21, 2010 | 1996 Chevrolet Caprice Classic

1 Answer

Will not start or turn over pass key fault light blinks when i try to start it 1996 Chevy Caprice


Make sure battery is fully charged. If so you may have a shorted starter, and it will nedd to be replaced.

Feb 02, 2010 | 1995 Chevrolet Caprice Classic

1 Answer

Powersteering IS LEAKING ON A 1991 CHEVY CAPRICE


IT NEED TO BE SERVICED. SECTOR SECTION IS WEAR. HURRY!

Apr 14, 2009 | 1996 Chevrolet Caprice Classic

2 Answers

Where is the thermostat located on the 1996 Chevy Caprice Classic?


Follow the upper radiator hose. It is in the housing the upper radiator hose is clamped to.

Apr 13, 2009 | 1996 Chevrolet Caprice Classic

1 Answer

Where is the valve for draining the radiator fluid on a 1996 Chevy Caprice Classic. It doesn't appear to be at the bottom of the radiator unless it is hidden.


the valve is on the back side of the driver or passenger radiator side tanks (engine side) crawl under the car to see it or open it.

Mar 31, 2009 | 1996 Chevrolet Caprice Classic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...