Question about 2007 Nissan Maxima 3.5 Sl Sedan

6 Answers

Transmission on 1999 chrysler concorde

I was driving and my check engine light came on,so i went and got a diagnostic check and it revealed a transmission code#. As i was leaving i put it in drive from reverse and it slipped into drive. It has never given me any problems what so ever. The car only has 62,000 miles on it. It is a 1999 Chrysler Concorde LX. I really baby my car,so I really dont understand why this would happen. Please Help!

Posted by on

  • joshuadaniel Mar 08, 2009

    The code# is 1784 it is a reverse to 1st code.

  • joshuadaniel Mar 08, 2009

    My car accidently was posted on the nissan page. My car is a 1999 Chysler concorde LX 2.7 liter engine.

×

6 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 19,396 Answers
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,011 Answers

You need to check your transmission fluid level in park. it is up to normal status .then i would replace the shift solenoid pack .it is low most likely the transmission cooler lines are seeping there is a tech service bulletin on replacing the hose clamps on the cooler lines .

Posted on Mar 09, 2009

  • 1 more comment 
  • mike loshbough
    mike loshbough Mar 10, 2009

    refill what trans fluid .also check the shift solenoid andvehicle speed sensor ..

  • mike loshbough
    mike loshbough Mar 10, 2009

    GINKO YOU ****

  • mike loshbough
    mike loshbough Mar 10, 2009

    the reverse valve body is hanging up so i would flush the transmission!

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 6,784 Answers

This is not your fault. the chrystler brand has Had many issues with there typical design of transmissions. unfortunately, you will have to allow the service tech to repair this issue. there is a fault in the shift lever design that , within time, it Begin's to strip out, causing it to slip out of range. this is a flawed design and not your fault at all.

Posted on Mar 08, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Nissan Master
  • 61,037 Answers

This is a shift solenoid pack issue, it is very likely that one or more of the shift solenoids is defective or shorted, they will need to be pulled out of the trans and tested for opens and shorts, there is no other way, this has nothing to do with how easy u do or don't drive the car, it is a computer transmission control fault.

Posted on Mar 08, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 948 Answers

The 2007 Nissans do not have Chrysler Concorde transmissions. You posted in one area, but the body of the post references a different vehicle. Which one do you have?

Posted on Mar 08, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 35 Answers

Do you know what the code was? That would be helpful. Most likley going to have to take it to a transmission shop. Its not really some thing that can be explained over the internet.

Posted on Mar 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I've got a 1999 Chrysler Concorde Speedometer wouldn't work transmission wouldn't shift Concorde


Your best bet would be to take it to AAMCO or some other repair shop an have them run diagnostics on the car . They could hook up scanner an be able to tell you right away , instead of replacing parts you don't need .

May 27, 2016 | 1999 Chrysler Concorde

1 Answer

1996 chrysler concorde when engine is running contrtol screen is dead and transmision wont change


Hello
The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type.

Sep 13, 2012 | 1996 Chrysler Concorde

1 Answer

1999 chrysler concorde my car wont shift out of second gear. Check Engine light is on now. dont know what to do, please someone help!


You need to take it to an auto parts store and have the computer scanned for trouble codes.
The codes will point you in the direction of the problem, but not tell you which parts have failed.
Odds are you will need a shop for repairs, but get the codes first.

Aug 03, 2012 | 1999 Chrysler Concorde

1 Answer

I HAVE A 1999 CHRYSLER CONCORDE LXI, CHECK ENGINE LIGHT COMES ON AND RPM RACE TO 4000 WHEN DRIVING 55MPH?


First thing is to have the computer scanned for trouble codes.
My guess would be a torque converter or overdrive problem.

Jun 26, 2012 | 1999 Chrysler Concorde

1 Answer

'99 Concorde won't shift into third. It kind of jerks when it hits second or downshifts into first. Check engine light is on. OBD codes are: P0734,P0731,P0733,P0700


all the codes listed above are saying incorrect ratio for each gear,you should take this to a dealer he can determine which faulty sensor on the transmission is causing this,it is not a internal transmission problem

Dec 24, 2009 | 1999 Chrysler Concorde

2 Answers

1999 concorde. in limp mode with check engine


you should also replace the input speed sensor,they should always be done in pairs and i have had both of them bad on numerous vehicles,hope this helps

Sep 09, 2009 | 1999 Chrysler Concorde

1 Answer

Hello ! my 1999 chrysler concorde shows (check


You need to have the codes read to determine what is wrong. Bring it to a parts store, this is a free service. They will plug a hand held scan tool into the cars diagnostic port (under the dash), and 'read' codes stored on the cars computer. They can tell you what the code(s) mean, and suggest how to fix the problem. If you have any questions after that, post the codes and questions (and engine size) here.

Aug 09, 2009 | Chrysler Concorde Cars & Trucks

2 Answers

1999 lxi.check engine light is on,but still car run well.


Get the free engine diagnostic from a local Advanced Auto or Autozone and ask them for a print out. The engine light could be any number of sensors and it can cause you problems when it comes to getting an emissions test (If your state.county has e-check). Hope this helps.

Jul 08, 2009 | 1999 Chrysler Concorde

1 Answer

Engine light on and transmission will not shift out of low gear tcm? 2003 chrysler concorde.


You will need to get the diagnostics done for the check engine light and get a transmission flush for yoru car.

You can save some money by checking a new website http://prundo.com/ for free coupons for check engine light and transmission flush. This website also has lots of fee coupons for other auto repair!

Mar 11, 2009 | 2003 Chrysler Concorde

Not finding what you are looking for?
2007 Nissan Maxima 3.5 Sl Sedan Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...