Question about 2006 Chevrolet Malibu

1 Answer

Ignition sensor fuse for 2007 malibu

What does the ignition sensor fuse for a 2007 malibu control?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 59 Answers

It controls your iginition, the spark, what makes your car start and run.

Posted on May 16, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the ignition control module located in a 2007 Malibu?

What engine does yours have ? 2.2 , 3.5 or a 3.9 L , there isn't an ignition control module . The engine control module (ECM) controls all ignition system functions, and constantly corrects the spark timing. The ECM monitors information from various sensor inputs .
Now , what seams to be the problem ? No spark ? Crankshaft position sensor could be the problem or cam position sensor .
Now ,what

Nov 02, 2015 | 2007 Chevrolet Malibu

1 Answer

Where is ign sensor fuse in 2011 malibu

There really is no " ignition sensor fuse" below is a diagram of the under hood fuse box. Circled is the Ign/crank relay and ECM ign fuse.

Oct 15, 2014 | 2011 Chevrolet Malibu

1 Answer

Cruise control not working on 2011 dodge grand caravan

the following items either individually or together stops the cruise control from working ( you didn't mention auto or manual box)
VSS, ( auto or drive shaft sensor in manual)
brake light switch / sensor/
clutch position sensor ( manual)
cruise control switch
wire to the ignition control module /tacho
cruise control module

Sep 03, 2013 | 2007 Dodge Caravan SXT Minivan New Cars

1 Answer

2001chevorlet malibu. No power to ignition, radio or enviromental controls

It is hard to tell, but maybe you cut some wire, or unplug it by accident.
Check you fuses again.

Feb 27, 2013 | 2001 Chevrolet Malibu

1 Answer

Hi I have a chevy malibu 05, it wont start when its hot already replaced the fuel pump and fuel fuse, still same problem

The next time it does't start check for spark at any of the sparkplugs if you have no spark then,check the crankshaft sensor for a signal if its good then its either the igniter or the ignition control module.

Aug 04, 2011 | 2005 Chevrolet Malibu

1 Answer

Where is the fuse box on the 2007 malibu maxx

The fuse box is located on the passenger's side of the console by the firewall. Just pull the cover off and you will see the fuses and a diagram.

Mar 28, 2011 | 2007 Chevrolet Malibu Maxx LTZ Hatchback

1 Answer

Dtc code p0121 and p2135 2007 chevy malibu

both codes refer to the throttle position sensor, the sensor is at the throttle plate, on the side of the throttle body. to test remove the connector to sensor, use a ohms meter to test. put 1 lead to top connection and the other to the bottom one. move throttle and the needles on the ohms meter should move very even, move throttle slow to get a good reading, needle should move without no hesitation, if the test is bad replace tps sensor. if the sensor gets to bad, it can have an effect on transmission shifting. after fixing sensor have the light turned of with an obd2 scanner.

Feb 14, 2010 | 2007 Chevrolet Malibu Maxx LTZ Hatchback

1 Answer

2004 malibu 4cly engine cranks wont start underhood fuses good fuel pressure 53psi

have you checked to make sure that you are getting fire to the plugs. i believe this is coil over ignition maybe not but pull off of one of the plugs take a plug out and stick in boot and see if they are firing if not it is a ignition control module problem or crank or cam sensor.

Aug 30, 2009 | 2004 Chevrolet Malibu

1 Answer

Car will not restart after running

If it turns over, but won't start when hot: first, change your air filter. 2. Check your engine ground connection. 3.Check for a loose connection in the ignition system 4. You could have a faulty idle control valve. 5 . Faulty coil, Mass air flow, idle control sensor... but you should have an engine light on if it's one of those.

May 26, 2009 | 2003 Chevrolet Malibu

1 Answer

4 cylinder 2007 chevy malibu

they have a reset circuit breaker they are not fused.

Sep 18, 2008 | 2007 Chevrolet Malibu SS Sedan New Cars

Not finding what you are looking for?
2006 Chevrolet Malibu Logo

Related Topics:

235 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

78010 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides