How to replace rear wheelbearing - 2007 Renault Kangoo 1.4

There should be a number stamped into the inner or outer race. I hope this helps. Take care.

wheel sensors are located at each wheel. they are either internal with ur wheelbearing or externally mounted near the hub . one some trucks like ford trucks the rear wheel speed sensors are mounted on top of rear differential housing.reading the ring gear for both rear wheels in one parameter

Dolores, i hope this what you wanted ,

removal of rear hub assembly, remove rear wheel, then put on jack stands, you will need to do this for both sides, with wheel and tire removed, you need to remove the rotor holding washers, once that is done, there is 4 bolts I think they are 17 mm, with a breaker bar, loosen the bolts, also disconnect the ABS system from the back of bearing, after all bolts are out, you need to use a hammer to lightly tap it to loosen it, to replace them just reverse the steps

No. The 1998 Pontiac Sunfire featured a more aggressive looking front fascia then the 1997 model. --------------------------------------------------------------------------------------------
KESS V2 OBD2 Manager Tuning

bad speed sensor in one of the wheelbearing gunna have to replace the wheelbearing with the bad sensor

Hi,
First you need the correct tools such as axle pullers and bearing extractor tools...Then it is just a case of removing the wheels and the brake assemblies from either side.
Once this is done then you can extract the axles to replace the bearings.
Thanks
Jason

You have an 2.2L DOHC or a 2.0L DOHC ECOTEC, either way same hub bearing for either size engine, with ABS brakes or without.

no they are a sealed bearing, so no u can't grease them.
here is the part number for them
SKF Part # GRW172
Wheel Rear; Sealed

It is a complete hub assy.