Question about 1990 Ford Ranger SuperCab

1 Answer

Stalled out my 1990 ford ranger stalled out on me. It happened in the past and would just start up again. It still turns over but just wont start. Any ideas.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Need to check your cam shaft position sensor. I just went through the same problem and had mine replaced and the truck starts no problem..

Posted on Apr 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes engine to ABRUPTLY shut off while driving ?


2004 Ford Explorer Engine Stalls/Cuts Out While Driving: 31 ...

www.carcomplaints.com/Ford/Explorer/.../engine/engine_stalls_cuts_out...
... 2013 · 2012 · 2011 · 2010 · 2009 · 2008 · 2007 · 2006 · 2005 · 2003 · 2002 · 2001 · 2000 ... 2004 Ford Explorer engine problems: engine stalls/cuts out while driving ...to overheat and slide out of its socket, causing the engine to shut off. ..... Suddenlyat 30-35mph, my engine just died and i cannot control the steering wheel.

2005 Ford Escape Engine Shutdown While Driving: 24 ...

www.carcomplaints.com/Ford/.../engine/engine_shutdown_while_drivin...
The 2005 Ford Escape has 24 complaints for engine shutdown while driving. ...January 22: Ford Ranger Driver Killed by Takata Airbag in South Carolina news ' 2 days ago; Ford Focus Door Latch ..... I was 80 miles from home when the engine shut off. .... No one could seem to determine the true cause of the problems.

Ford Ranger Stalling/Dying Problems - Edmunds.com

forums.edmunds.com > Ford > Ford Ranger

Nov 2, 2007 - 31 posts - ‎21 authors
Learn more about Ford Ranger at the Edmunds.com Car Forums! ... cut off a couple of times then it started happening more frequent while driving. ..... the other day I was driving down the highway and it just shut off, no warning .... 2000. when it gets overheated the circuit shorts and causes the engine to die. Ford Expedition engine cutting off while driving
31 posts
Oct 24, 2009
Mercury Mountaineer Start Stall Idle Problems
31 posts
Oct 1, 2007
More results from forums.edmunds.com

Jan 27, 2016 | 2003 Ford Ranger Regular Cab

1 Answer

1999 ford ranger problems


A good idea to check the compression before anything else. Look for compression figures in the 100-160 psi range and evenly balanced. Lowest compression should be within 75% of the highest reading. Anything below 100 psi is a problem cylinder.

Mar 01, 2014 | Cars & Trucks

1 Answer

I got a 1990 ford ranger 2.9 v6 its running very crappy


Fluctuating an high RPMs sounds like a leaking or missing vaccume hose to me, I had simmilar problem found open hole with hose off, replaced it now the RPMs are under 1000 again.
As for the stalling I also am having a simmilar problem, and am finding air in the fuel rail, I suspect the fuel pump is going.
I cant go more than a mile without problems.

Dec 03, 2009 | 1990 Ford Ranger SuperCab

1 Answer

88 Ford Ranger2.9L v6,will occasionally stall out.Will then not start,motor turns overs.Wait five minutes then starts up.Any ideas on what's up.


It Could Be The TFI Module On The Distributor They Will Cause That Problem When Hot Then When It Cools It Will Start Again Change The module

Jul 14, 2009 | 1988 Ford Ranger

1 Answer

I have power but my 1990 ford ranger clicks loudly and wont turn


Starter could be stuck..
If you are SURE you battery is fully charged with no dead cells..
Try --
(takes 2 peopl) -
Turn the key like you are trying to start it.
At the SAME time - smack the starter with a small hammer not too too hard..
Let me know what happens..

Jul 09, 2009 | 1998 Ford Ranger SuperCab

2 Answers

1990 Ford Ranger Stalling


if it were me I would start with the idle air controll sensor, this is a real humdinger on fords. also clean out your throtle body really good.

let me know

tepfy

Apr 22, 2009 | 1990 Ford Ranger SuperCab

1 Answer

1990 ford ranger 2.3L running rough at idle and while driving


Hi check all the fuse. fi the fuse are ok . remove the coil pack and reverce if the cly missifire change replace the coil if not chage replace the electronic comtrol module ok.

Apr 20, 2009 | 1990 Ford Ranger SuperCab

1 Answer

Engine stalling out when hot


I would have the control module checked. It is mounted to the back of the distributor. You can take it by any autozone to be tested. This component heats up and then starts to break down inside,, when it cools back off then you are able to start back up until it goes completely out.

Jun 18, 2008 | 1990 Ford Ranger SuperCab

Not finding what you are looking for?
1990 Ford Ranger SuperCab Logo

Related Topics:

226 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...