a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Do you have under drive pulleys? If so, you can expect that to happen. It does not mean that something is wrong. You may have a high volume oil pump too. I have under drive pulleys on my Camaro and the oil pressure and voltage readings go up. I have never had a problem with that. I would worry when the oil pressure gauge does not move at all $$$$$$.
your pressure sending switch could be going bad id try replacing that first its easier and cheaper. make sure the oil level is not too high also.if all is good then the switch can be bad or the gauge itself.
if the gauge starts a 0 - goes to 1/2 , than full - sounds like gauge is OK - seems to me like the sending unit is bad - you could try removing the sender and trying to clean out the port with "brake clean", letting it dry than re-installing it. the pressure switch is still the least expensive place to start
If your oil pressure is running in the red this would indicate too much oil in the system. You should have your oil changed and refilled soon or you run the risk of burning out the oil pump. At idle your pressure should be just over a quarter of what your gauge has. At highway speed it should not exceed 3/4 of the gauge unless your going in excess of 100 MPH. Change the oil and filter and your vehicle should be fine.
If grounding the dash does not work, try putting a mechanical gauge on it and reading actual oil pressure. Pressure does change while driving, but should not wander. With mechanical gauge, check that running hot at idle (in gear if automatic) pressure should not drop lower than 15psi (I'd rather see 20) High reading should be around 40 -50 but no higher.Low pressure indicates a loss of supply or bad bearing on the crankshaft, high pressure may be caused by sticking pressure relief or restriction in an oil passage.
If the weather in your area is colder than normal, your startup oil pressure will reflect this, essentially because it is much thicker when very cold. This high reading should drop to "normal" once it reaches operating temperature. This condition can also be caused by a sticking pressure relief in the oil pump, usually caused by sludge inside the engine. If you regularly maintain your vehicle and use good quality oil, this should not happen. The oil pressure sending unit is also suspect, but in your case, I would not put it at the front of the list. If oil is close to "change time" consider using a good synthetic oil (synthetics flow better at extreme temps) or using a 5W anything oil during winter months. (see manufacturers specs)