Question about Hyundai Motor 1999 Elantra

1 Answer

Instuctions to remove and replaceengine and trans on 99 hyundia

Posted by on

  • yadayada
    yadayada May 11, 2010

    u are going to have to invest in a factory sevice manual. many pages of instructions and not availiable at this site.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

Try "autozone.com" or your local library for diagram and step by step instructions

Posted on Mar 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trans missom oil filter for hyundia trajet v6 how to change


transmission oil filters are normally inside the transmission and will require the pan to be removed . They will not need attention unless you have drastic problems with the transmission
Mostly all that is needed is a an oil change

Feb 04, 2015 | Hyundai Trajet Cars & Trucks

2 Answers

I need to know where the transmission filter goes on my 2004 hyundia sonata 4 cycle.


Trans filter is attached to bottom of transmission. You must drain & remove transmission pan to access it.

Mar 24, 2011 | Hyundai Motor 2004 Sonata

1 Answer

Hi i have a 99 hyundia elantra my check engine light is on the codes are p1624,p0137,p0732and p0740 are these codes connected or different problems


As for p1624 this code is for the accent only.
p1613 means the same thing but for the elantra, the
code means malfunction indicator light(mil) signal
circuit input high volt. p0137 means ho2sensor high
voltage (fuel pressure out of range high) p0732 is a
transmission code. It means that due to a malfunction in the trans. circuit, the trans. will operate in limp mode meaning you have reverse and
one forward gear in this case 2nd gear. That brings
us to p0740 this code indicates a malfunction with
the damper clutch control solenoid at the trans. this
would cause the p0732 limp mode. But if your car
is not showing any of these problems, the cause may
be the engine control module or the transmission
control module. But this would have to be checked
with the proper test scanner. Hope this helps.

Feb 19, 2010 | Hyundai Motor 1999 Elantra

2 Answers

99 Chevrolet S-10 Removal of Transmission Front Pump Seal


Just a seal removal tool or a screw driver, pops right out.

Feb 17, 2010 | 2003 Chevrolet Tahoe

1 Answer

2001 HYUNDIA ELANTRA AUTO TRANS THE TRANS


You really need a test drive by a tech. Any shop should be able to do that and give you a firm (written) estimate. It might not be a big deal. Shop around if you need a rebuild, If you need one, ask about their warranty. Believe it or not, a good reference for a tranny shop is the Used Car Manager at the Hyundai dealership. Go in to ask him, not over the phone, and be nice. You're asking for a favor after all. Many dealers do a lot of their work outside the store for reasons of cost. It all depends on the dealership. One will, one won't. Ask.

Jun 11, 2009 | 2001 Hyundai Elantra

1 Answer

Where is the trans speed shaft sensor on a 2001 hyundia santa fe?


There are two speed sensors, Input sensor is located on top of the bell house. Output sensor is located on the firewall side of the bell house.

May 25, 2009 | 2001 Hyundai Santa Fe

2 Answers

What type transmission fluid should be used in an 04 GX350 Hyundia?


GENUINE HYUNDAI transaxle oil, GENUINE DIAMOND ATF SP-III or SK ATF 3 for automatic trans

Dec 05, 2008 | 2004 Hyundai XG350

1 Answer

Transmission filter on 2003 hyundia santa fe


In 2002 they discontinued the external trans filter. So your vehicle could have the external filter. If you look next to the trans dipstick tube, on top of the trans case you will see the filter or you will see just a spot where the filter use to go before they eliminated it. Yes, the filter does llok like a regular engine oil filter. If the trans does not have the external filter ontop then there is no service to the filter to be done, the only recommendation is to bring vehicle into a shop to have the fluid flushed. By the way, make SURE you use the correct Hyundai SP-III trans fluid (not dexron/mercon). This fluid is specific to the Hyundai and can not be purchased from auto parts stores, only the dealership. Failure to use SP-III will cause premature wear to the internal bands and clutches.

Oct 18, 2008 | 2003 Hyundai Santa Fe

Not finding what you are looking for?
Hyundai Motor 1999 Elantra Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...