Question about 1998 Mercury Mountaineer

2 Answers

1998 Mercury Mountaineer Plastic Fan

How much trouble is it to replace the plastic fan on 1998 Mercury Mountaineer. Just pull off the shoud and remove the bolts holding on the fan?

Posted by on

  • Anonymous Mar 17, 2014

    remove, replace

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

If it's anything like my 1999 Mercury Mountaineer, you will probably have to pull the fan/clutch assembly off with the fan attached. Then you can remove the fan. You can purchase a fan/clutch wrench set at a local auto parts store for around $20. The fan/clutch assembly can be removed with the fan shroud at the same time.

Posted on Jun 24, 2012

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

Yes this sounds correct but if you want to get a diagram and step by step instructions try "autozone.com"

Posted on Mar 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove water pump on 2002 mercury mountaineer


You have to start with removing battery neg cable then start pulling fan shroud and fan clutch and then most of the time the radiator has to come out and anything else in front of the water pump. Dont forget to drain radiator into something big enough to hold all the fluid. The thermostat should be replace at the same time

Dec 04, 2015 | Mercury Cars & Trucks

1 Answer

How do i remove my rearview mirror w/temp & comp.


because the plastic inside has probley broken causing it to move freely.

Feb 03, 2013 | 1998 Mercury Mountaineer

1 Answer

1998 Marquis heat/AC system stopped running


just did one , the heater motor quit , and nothing works , replace the heater / blower fan motor , under the hood , passangers side , you'll have to remove the windshield washer tank and i found it was easier to jack the passangerside up , remove the passangerside wheel and remove the screws from the plastic inner fenderwell , at least the back ones . sorry it isnt easier , but thats what i went thru

Jun 22, 2012 | 1998 Mercury Grand Marquis

1 Answer

How do u add antifreeze to a mountaineer


OVERHEATING

Physically look in the radiator under the cap when cool, for coolant level, and check the valve in the cap for sticking. If air is present in the radiator it can't get out, and more coolant can't get in,(from the overflow). Either clean the cap or replace it and check that it is the CORRECT cap.

If radiator is low on coolant fill it to overflowing, replace cap, and check that coolant overflow is filled to the COLD line or mark. The overflow is normally where you would add coolant.
Radiator fins dirty, clean with a strong stream of water, not high pressure water.
Radiator clogged, try backflushing it, or replace.
Thermostat stuck open or shut, replace it.
Water pump worn out, can no longer move enough coolant, replace it.
Fan shroud broken or missing....
Electric Fan(s) not working, Check the fan, relay, fuse and engine temperature sensor's.
Belt driven fan, belt slipping, fan clutch is bad, fan blades have flattened out.

Air dam under front bumper is gone, loose, or broken. It actually has a purpose other than scraping on the driveway or curbs. It forces air up into and thru the condenser and radiator. If it's loose, airflow can actually push it out of place making it useless or blocking the airflow. Along with that, there may also be a plastic piece attached to the bottom of, and wraps up behind the bumper. If it

Aug 27, 2011 | 2004 Mercury Mountaineer

2 Answers

Does the fan and fan schroud need to come off to replace the radiator


Yes,

Hold the fan clutch steady with a fan clutch wrench and disconnect the fan using a fan hub wrench. Notice the fan remains held in the engine compartment by the fan shroud...

Remove the two bolts securing the fan shroud to the radiator, with a ratchet and socket. Pull the fan shroud and fan blade assembly from the engine compartment.

Jul 21, 2011 | 1997 Mercury Mountaineer

1 Answer

There is a loud chattering noise coming from the front of the engine. Seems to be the sooling fan assembly. Could it be the water pump as well?


Sounds like the fan blade is hitting the plastic shroud around it. With the engine off and a flashlight, spin the blade by hand to see where it is hitting.

Mar 19, 2010 | 2004 Mercury Mountaineer

1 Answer

My 1998 mercury mountaineer over heated back filled the overflow


you need to make sure your cooling fans and relays
are working, remove the thermostat and try just in case yours got stuck closed,if it remains ok,then install a new thermostat

Dec 25, 2009 | 1998 Mercury Mountaineer

1 Answer

How to remove the fan from an 04 mountaineer


This has a thread on fan clutch that you will need a spanner wrench for.

Dec 13, 2008 | 2004 Mercury Mountaineer

Not finding what you are looking for?
1998 Mercury Mountaineer Logo

296 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...