Power windows on a 1998 ford winstar do no work

Here's a new one with free shipping. NEW OEM Ford Window Lift Motor Front Left F78Z 1623395 AA Ford Windstar...

I HAVE THE SAME PROBLEM ON MY 98 FORD WINDSTAR, A 2001 ENGINE WAS INSTALLED ON IT AND ALWAYS VIBRATES, IF SOMEBODY KNOWS WHAT THE PROBLEM IS, PLEASE POST SOLUTION

1998 Ford Windstar 3.8 liter V-6 VIN "4"




1998 Ford Windstar 3.0 liter V-6 VIN "U"



Hope helps (remember rated this).

Your front ABS sensors are bad.

Check your vacum hose to master brake cylinder.
Check your oil level, check your brake rubber cables.
Could be leak in rear brake cylinders

Possible you have a vaccum leak or blockage.The direction of flow for heat and air is controlled by way of vaccum lines.

put a socket at torque bar on the bolt ant turn counter clockwise.

DTC P0156 indicates the output voltage of the downstream Heated Oxygen Sensor (HO2S) is less than some calibratable functional window. The possible causes are:

1. Pinched, shorted and/or corroded wiring and pins.
2. Crossed sensor wires
3. Exhaust leaks.
4. Contaminated HO2S.
5. Bad HO2S.

Since you didnt specify the engine size in your vehicle - please see the diagram below for the location of the sensor(s)


Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Its most likely the tappets in the cars engine the only way to fix it is to buy new ones.

That's an 02/oxygen sensor code means that bank 1 or 2 is too lean. Good Luck contact if you need more help.