Question about 1996 Toyota Tacoma
It stops working (at all speeds) for anywhere from a few seconds to a few minutes. It will come back on and work fine. Is it the blower motor or the resistor?
SOURCE: Blower motor has only low speed
You may need to get the correct resistor, as they are designed to only allow so much amperage to go through them. If it is getting very hot it is runnig to many amps through it. It will eventually blow and you will need to replace it anyway.
Posted on Jul 28, 2008
there is no relay for the heater fan it's a 15 amp fuse and is on the accessories circuit. the reostat is responsible for all 3 speeds .with the key off there should be no voltage to the blower motor whether the fans speed fan switch is on or off. the fuse will be located in the fuse paneleither on the drivers left side in the dash or underneath the dash in the fuse block. you have a short in the harness that is under the dash and most likely it's a bad plug on the harness. your going to have to do some searching but that's where the problem short is... please rate
Posted on Oct 04, 2008
SOURCE: Heater Blower Motor
Remove the glovebox door, and the under dash cover/trim panel.
Look behind where the glove box was, you will see the heater box
At the bottom of this box, there is a round plate with a wiring connector and 3 screws holding this plate to the heater box.
This plate is the bottom of the heater fan assembly; remove the connector, and the 3 screws. The fan motor will drop staright down. Real easy to do.
Posted on Oct 21, 2008
yeh its located under the passenger side glove box,its in the heater box beside the heater motor ,,2 scews hold it in and it looks like a credit card when its out,,,,
Posted on Apr 19, 2009
Tips for a great answer:
Oct 09, 2014 | 2006 Chevrolet Equinox LT
Apr 13, 2014 | 2001 Pontiac Sunfire
May 21, 2013 | Cars & Trucks
Jun 01, 2012 | 2006 Toyota Tacoma
Jan 13, 2011 | 2006 Toyota Tacoma
Jul 03, 2010 | 2005 Jeep Liberty
Mar 11, 2010 | 1996 Jeep Cherokee
Feb 04, 2009 | 1996 Cadillac DeVille
85 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: