Question about 2000 Nissan Xterra

2 Answers

Trying to replace the knock sensor in my 2000 nissan xterra 4wd/v6...can't locate it!!

Posted by on

  • Anonymous Mar 08, 2009

    my knock sensor just went out on my 2000 xterra i seen u had the same problem did u get it fixed if so how and how much it is my knock sensor bank 1 / any help ??

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

  • Expert
  • 21 Answers

Full instructions on your service manual. Download it now!

Posted on Jan 16, 2015

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 35 Answers

From the service manual:Trying to replace the knock sensor in my 2000 - 457bed1.png

Posted on Aug 05, 2009

  • lee emory Aug 01, 2012

    no the sensor have not been repaired yet

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Crankshaft sensor on a 2000nissan xterra where is it located and how can it be replaced


crankshaft position sensor location for 3.3 V6 engine is mounted at the rear of the engine on transmission bellhousing, the 3.5 V6 engine crankshaft sensor located at front of the engine on the aluminum oil pan section below crankshaft pulley.replace the crankshaft position sensor remove heat shield disconnect the electrical connector the remove sensor retaining bolt then remove crankshaft sensor.after replacing crankshaft sensor you need to erase code if check light come back on.

Nov 14, 2011 | 2000 Nissan Xterra

1 Answer

Are there 2 knock sensors on an 2004 nissan xterra 2 wd. V6 n were are they located


I have looked everywhere and also went to my 2 of my parts suppliers and there is only one knock sensor for your vehicle. Below are pictures right out of my Nissan Factory Service Manual and it does only list 1 knock sensor. If you have any questions or need any testing procedures feel free to email me at csautomotivecars@att.net. and I will send what I have.


clifford224_380.jpg

clifford224_382.jpg

Aug 26, 2011 | 2004 Nissan XTerra

1 Answer

Knock sensor 2000 nissan xterra V6, location of sensor? how to change knock sensor?


Hello the sensor is located under your intake manifold you will need to remove the intake manifold to gain access to it here is photos of what and where your looking for thisregeetone_0.pngregeetone_21.jpg

Jan 23, 2011 | 2000 Nissan Xterra

1 Answer

Where is the knock sensor located


Thank you fo using Fixya

For your 01 Nissan xterra V6 3.3L. The sensor is located underneath the air intake manifold on top of the engine block.

All the best!

Nov 17, 2010 | 2001 Nissan Xterra

1 Answer

Removal of knock sensor on 2000 nissan xterra v6 3.3


very labor intensive repair.not for a novice. its under the lower intake. way down deep. You dont realy need to replace it unless your xterra is supercharged.

Sep 22, 2010 | Nissan Xterra Cars & Trucks

3 Answers

Diagram available for 01 Nissan Xterra Knock Sensor location?


V6 3.3L The sensor is located underneath the air intake manifold on top of the engine block. This should take an experienced mechanic about 3-4 hours to replace.

9bd8ec7.jpg

Fig. Engine compartment component locations

Hope this help (remember rated this free help) Good luck.

Feb 08, 2010 | 2001 Nissan Xterra

1 Answer

Where is the knock sensor for the 04 nissan xterra located?


Your knock sensor is located undernesth the air intake manifold on top of the engine block. This goes for 2000-2004 xterra V6 3.3L models.

Nov 05, 2009 | 2002 Nissan Xterra

1 Answer

2000 Nissan Xterra Service Engine soon indicator is always on


The knock sensor is not a huge deal to replace and will not turn on the light. It should be dont though.

The crankshaft sensor is located directly between the engine and transmission. It is dead center at the bottom.

May 17, 2009 | 2000 Nissan Xterra

1 Answer

Where are the knock sensor for nissan xterra 00?


On 4 cyl engines the knock sensor is on the side of the block.
On V6 engines it is located under the intake manifold.

Apr 04, 2009 | 2000 Nissan Xterra

4 Answers

Nissan xterra knock sensor


It's the valley of the engine underneath the intake manifold. It's about an $800 job because the top of the engine has to come off. However, unless you have a supercharged xterra it shouldn't effect performance. Also, the knock sensor will not trip the check engine light, as it does not indicate a primary problem, so if your light is on you should have another code that should be fixed first.

Nov 05, 2008 | 2002 Nissan Xterra

Not finding what you are looking for?

Open Questions:

See all 2000 Nissan Xterra Questions

2000 Nissan Xterra Logo

Related Topics:

946 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...