Question about 2001 Honda Civic

1 Answer

Parts breakdown for left strut assy. - 2001 Honda Civic

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert that hasĀ over 500 points.


    An expert who has answered 200 questions.

  • Expert
  • 214 Answers

Parts? All ya have is upper/lower mounting bolts, a spring and rubbers.. and the strut assy. itself

Posted on Mar 08, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I need help replacing rear struts on a 2004 dodge stratus sedan

jack up the car and take off the wheel. go through the trunk and remove the trunk liner from the wheel well area. remove the two nuts off either of the center, dont remove the center one yet. now you remove the bolt from the bottom of the strut and remove the strut assy. you can buy new struts as a complete assy. or you will have to use a spring compressor and compress the spring until it is loose from the spring pad, then remove the nut from the top of the strut and it comes apart. a lot of times the rear mount goes bad on these cars and it makes noise on the bumps. it doesnt mean the strut is bad. you can check the strut by pushing the rod in and pulling it out, there should be steady resistance. any easy spots and the strut is no good. gas struts should fully extend by themselves from the gas pressure, if they dont, they are bad.

Oct 10, 2014 | 2004 Dodge Stratus

1 Answer

Clunking in the front passenger side when breaking and turns weird

One common thing on those if brakes have been checked is the strut bearing assy at top of front struts. Grinds and thumps especially when turning. If not experienced at changing them, don\'t attempt it as it can be very dangerous. You can buy a complete strut and bearing assy, but if too hard on the wallet, get quote from parts store to change bearing for you, or an auto service.

Dec 27, 2013 | 1998 Plymouth Grand Voyager

1 Answer

Who makes a complete strut for 1996 buick century without taking the whole strut apart, front

You take your strut assy to a repair shop

They will switch the spring over to new strut

Every Company making struts --also make complete
assy's with the springs

I wouldn't waste may money going that route,but
you can

Still has to be Aligned

Dec 21, 2012 | 1996 Buick Century

1 Answer

Turning wheels full left and right I get a thud like noise both directions

Check for a bad strut bearing ,up on top
of strut assy in upper inner fender

Also make sure that none of that noise is coming
from steering rack or something worn or loose
like a stabilizer link

Jul 02, 2011 | 2005 Ford Taurus

2 Answers

I wanted to know how i can replace a bad strut with out taking off my head to do it. the plate that holds the spring in place came unwelded as well.

have you heard of Harbor Freight Tools? they sell a inexpensive strut spring tool that collapses the spring works great.

Jan 02, 2011 | Dodge Intrepid Cars & Trucks

1 Answer

Both rear shock's are bad need a picture ofhow they are disassembled any help with be good

this car does not have rear shocks, it has struts, you will need a strut compressor to replace them, also this model has a problem with the upper bearing mount they go bad a lot and make a knocking noise when you hit a bump. try this see if you can by the strut as a complete assy. they are offered that way but not by all parts stores. if you buy them as an assy. them all you have to do is jack up the rear of the car and put jack stands under it, remove the rear wheels, open the trunk and get in remove the carpet/cardboard covers over the wheel wells, and remove the 3 nut that hold the top of the strut assy. then remove the lower mount bolts. and swap out the hole-assy......HAVE FUN

Nov 18, 2010 | 1994 Pontiac Grand Prix

1 Answer

I hv a '01 Aurora w/ 105000miles. On choppy pavement, the rear tends to skip sideways w/assoc knocking noises like worn or loose struts. Left rear tire on outside shows more wear than the other three....

This is related to the "link assy" parts on the rear end. They are about 30" long. One end bolts near the center of the car. The other ends have a tie-rod type end and mount to the rear wheel assembly.
The knocking noises are because the link assy are bad. About $70.00 each for these. I would also check the upper shock mounts on the rear. These go bad and will cause noise as well. About $15.00/ea. Easy to replace.
The skip sideways is because the link assy or rear alignment is off. This is easily fixed and should be done as soon as the parts are replaced.

Oct 04, 2010 | 2001 Oldsmobile Aurora

1 Answer

How to replace the rear springs and what size are brake lines.

rear springs are part of a strut assy, get a quick strut fom o'reilleys or az. it has the spring, strut, mount, all new and ready to pop in, otherwise you will need to tear the strut down and will need special tools. it is also a little risky, springs can fly pretty good when they slide out of compressors

Jul 07, 2010 | 1998 Ford Escort

1 Answer

Change out Front Struts

If you've never done them before it could be very dangerous I've seen experienced mechanics have them fly across the room, and thank God , no-one was standing in the path. There are other parts that should probably be replaced when doing the struts, like upper mounts/bearings etc., otherwise you may be sorry you didn't real soon, from the grinding, thumping etc. What most guys are doing these days, is buying the "Quick Strut kits" or whatever name your supplier may be using. Basically it's a complete new strut, spring, bearing/mount assy., all in one, already done for you. You just unbolt from above & below & switch them. Price it out & see if it isn't too bad, I'd go with that, then you also pay for one alignment. Many a guy has changed struts, got alignment, then bearing/mounts started making noise, then changed them, which basically means all the same work again, and another alignment. Up to you, but I'd think about it if those other parts haven't already been changed. Hopefully you can get a credit back on struts you bought to put toward complete assy.Check out this link to autozone.,2624239/vehicleId,2316702/initialAction,partProductDetail/store,/partType,00660/shopping/partProductDetail.htm

Oct 14, 2008 | 1993 Dodge Caravan

1 Answer

Drivers side front bearing assy.

yes go to and look for alldata or you will see the link to do it your self

May 30, 2008 | 2003 Chevrolet Silverado 2500HD

Not finding what you are looking for?
2001 Honda Civic Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides