Question about 1999 Chrysler 300M

1 Answer

Chrysler anti theft system 2000 300m

Keys were jerked from ignition while in drive was able to start it get it home now it won't start ignition switch won't even turn

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 153 Answers

Sounds like the tumblers were messed up. The key shouldn't come out while the ignition is on. If I am right, this has one of those very expensive "Chip" keys? Buying a new key could be more expensive then a lock cylinder. It will probably be cheaper to keep those keys then buy new ones on top of whatever it takes to repair the damage to the lock. You may be better off calling a "Locksmith". Even a new lock cylinder will have to be coded to something. You should be able to find a locksmith that will make a service call.
Let me know how that goes?

Posted on Apr 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I reset the ProLock system?


Hi Carol , do you mean PATS passive antitheft system ? Locked up your car ,do you mean it won't crank over an start ?
The passive anti-theft system uses radio frequency identification technology to deter a driveaway theft. Passive means that it does not require any activity from the user.
  • During each vehicle start sequence, the ignition key identification code is requested by the vehicle protection anti-theft electronics.
  • If the key's ID code has been programmed into the system, the powertrain control module (PCM) (12A650) is signaled to enable the vehicle to start.
  • If the key's ID code is not programmed into the system, or if no encoded key is detected, then the powertrain control module is signaled to disable the vehicle.
The passive anti-theft system communicates the state of the security system to the powertrain control module via the J-1850 communications network data link connector (DLC). The powertrain control modulebased on the communications from the passive anti-theft system, will determine if the vehicle's engine is enabled to start. The passive anti-theft system differs from the active anti-theft alarm system in that the passive anti-theft system enables/disables the vehicle from starting and only operates with the ignition switch in RUN/START position. The active anti-theft alarm system has perimeter protection capabilities and operates only with the ignition switch OFF. Refer to Section 13-11A for active anti-theft alarm system information.
Vehicle Disabling The passive anti-theft system will be activated and disable the vehicle from starting if any of the following conditions exist:
  • damaged encoded key
  • unprogrammed key
  • non-encoded key (key has no electronics)
  • wiring concern
  • transceiver concern
  • Passive Anti-Theft System (PATS) control module concern
  • J-1850 Communications Network concern
  • Powertrain Control Module (PCM)

Apr 15, 2015 | 1995 Ford Taurus

2 Answers

89 firebird anti theft code won't let car start


If code 53 involves the PASS system for your car, the chip in the key has failed, or the sensor in the lock cylinder, or the control module.
The anti-theft system disables the starter and the fuel injectors. You could bypass those circuits to get the car started.

Oct 02, 2012 | 1989 Pontiac Firebird

1 Answer

E320 key won't start 1st try


It is a key issue most likely, try unlocking the car and taking a little more time to insert key into igniton than you normally do to see if that works. It can be a coding/timing issue in the anti-theft logic and most times replacing the key is all that is needed. otherwise it is the EIS acronym for electronic ignition switch which is a major control unit for the starting and anti-theft system.

May 17, 2012 | 2005 Mercedes-Benz E320 Sedan

1 Answer

Replaced ignition switch in 1999 chevy cavaliar rs, anti-theft light comes on and stays on and won't allow car to start and remain on or run


You have to do a relearn procedure on the anti-theft system:

Attempt to start the vehicle. Leave the ignition on until the THEFT SYSTEM indicator turns off (about 10 minutes). Turn the ignition switch off. Leave the ignition switch off with key in for about 10 minutes. Attempt to start vehicle.

May 24, 2011 | 1996 Chevrolet Cavalier

2 Answers

My theft light is flashing but my 1997 expedition wont start.The vehicle turns over but just don't start.


ANTI-THEFT SYSTEM Passive anti-theft system
Your ignition key has a unique imbedded transponder which engages engine electronics and allows the vehicle to be started. Without the use of your special ignition key, the vehicle will not start.

During each vehicle start, the coded key is read by the anti-theft system. If the key’s ID code matches the code in the anti-theft system, the vehicle is enabled to start.

Anti-theft system
Briefly illuminates when the ignition is turned to the ON position to verify that the passive anti-theft system is operating properly.

Also, its possisble that tou have actovated the fuel pump switch.

CHeck it.

Jul 20, 2010 | 1998 Ford Expedition

1 Answer

My 2001 pontiac ssei says to service theft system


I would take it to a dealer and have the ignition switch looked at, That is either pass key (pk stamped in key) or pass key 3 (pk3) and the ignition switch is probably having trouble reading to key to disengage the anti theft system, eventually it wont let the car start, and it never happens when your home!

Feb 11, 2010 | 2001 Pontiac Bonneville

1 Answer

Replaced the alternator, now anti theft won't disable


The ignition lock anti-theft switch (19A438) detects if the ignition key cylinder is broken or "slam pulled" during a theft. The ignition lock anti-theft switch is always monitored by the remote anti-theft personality (RAP) module. This allows the alarm system to be triggered in the case that the ignition lock anti-theft switch detects tampering of the ignition key cylinder (even in the event that the alarm is not active at the time).
Refer to the Section 501-14B for more details on the keyless entry remote transmitter (15K601).
The door open warning lamp switch (14018) communicates to the RAP module through the generic electronic module (GEM). This input to the RAP will cause the anti-theft alarm to be sounded if the anti-theft alarm was armed.
The door disarm switches are assembled into both LH and RH lock sets. The door disarm switch must be triggered before the mechanical lock unlocks. This is to prevent the anti-theft alarm from activating when it should have been disarmed.
The RAP module controls the anti-theft system and is the brains of the keyless entry system. The RAP module communicates with the GEM to request that the interior lights be turned ON/OFF with use of the keyless entry remote transmitter, and the GEM communicates to the RAP to inform when the door is opened. Refer to Section 418-00 for inter-module communication.
The RAP module has three wire connectors attached to it:
  • The antenna for the keyless entry remote transmitter.
  • 26 circuit connector (C256).
  • 22 circuit connector (C257).
In addition to the perimeter alarm that uses the door open warning lamp switch, the RAP module also uses the ignition lock anti-theft switch and the autolock/relock feature to prevent theft of the vehicle. For a full description of the autolock/relock system, refer to Section 501-14B .
The THEFT LED is found on the instrument panel between the tachometer scale and the needle pivot point. The LED is illuminated during prearming and flashes when armed or triggered.
Prearming and Arming the System
The system can be armed if:
  • The ignition is OFF.
  • The PANIC alarm is OFF.
  • All doors are closed.
There are two ways to prearm the system:
  • Press the LOCK button on the transmitter.
  • Open a door, press the power door lock button and close the door.
After 30 seconds the system will be armed and the theft indicator in the cluster will flash every two seconds.
Disarming an Untriggered System
An armed system will be disarmed with one of these valid actions:
  1. Pressing the UNLOCK button on the transmitter.
  1. Placing a key in the door and turning to UNLOCK.
  1. Turning the key to RUN or ACC.
The anti-theft alarm can be triggered by the following conditions:
  • The ignition cylinder is damaged with or without the RAP being armed.
  • A door is opened without disarming the armed RAP module.
The remote transmitter can activate a panic alarm which is similar to an anti-theft alarm, but does not deactivate the starter or cause the theft indicator to flash.
Disarming a Triggered System
If the system has been triggered, (the horn honks, the lights flash, and an external starter interrupt relay is engaged), the system can be disarmed by:
  1. Pressing the UNLOCK or PANIC button on the transmitter.
  1. Putting a key in the door and unlocking the door.
  1. Turning the ignition to RUN/ACC (Turning the key to RUN/ACC will not disarm an alarm that has been triggered by the ignition lock anti-theft switch.).

Apr 10, 2009 | 1997 Ford F150 Regular Cab

2 Answers

Anti theft light comes on when driving


no cutoff switch!! try this turn key to on, do not start car. let sit for about 30 minutes, after 30 minutes, turn key off. wait 15 seconds and try to start car. this should reset anti theft system.

Feb 20, 2009 | 2000 Chevrolet Malibu

1 Answer

Anti theft system


The chip is in the key. Either the key has lost it's program or the transceiver is not recognising the key. Try another key if you have one.

Jan 26, 2009 | 1998 Ford Mustang

3 Answers

How to reset my factory car alarm in a 1999 mercury cougar v4 2.0? thanks


1999 cougar. before they tell me I need a fuel pump I want to be SURE the anti theft system has not shut off the fuel to the engine.
how do I confirm that?

Dec 08, 2008 | 1999 Mercury Cougar

Not finding what you are looking for?
1999 Chrysler 300M Logo

363 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...